JVC XV-522SL manual Troubleshooting, Symptom Possible case Remedy

Page 47

Additional information

Troubleshooting

What appears to be a malfunction may not always be serious. Please go through the following list before requesting service.

Symptom

Possible case

Remedy

 

 

 

 

Power does not come on.

Power plug is not inserted securely.

Plug in securely.

 

 

 

 

Remote control does not work.

Too far from the unit.

More closer to the unit.

 

 

 

 

 

 

The tip of the remote unit is not

Point the infrared light- emitting window

 

 

pointed in the right direction.

toward the remote sensor on the front panel.

 

 

 

 

 

 

Batteries are exhausted.

Replace the batteries with new ones.

 

 

 

 

 

 

Battery polarity is incorrect.

Take out the batteries and insert them again

 

 

 

in the correct direction.

 

 

 

No picture is displayed on the

Connection of video cable is

Connect the cable correctly.

monitor.

incorrect.

 

 

 

 

 

 

 

Input selection of TV is incorrect.

Select correctly.

 

 

 

 

 

 

Disc is not playable.

Use a playable disc. (See page 11.)

 

 

 

Picture is noisy.

The unit is connected to a VCR

Connect the unit so that the picture signal

 

 

directly and the copyguard function

flows directly to the TV.

 

 

is activated.

 

 

 

 

No audio is reproduced.

Connection is incorrect.

Check the connections.

 

 

 

 

 

 

Input selection of amplifier is

Select correctly.

 

 

incorrect.

 

 

 

 

No audio is reproduced when

The audio signal is derived from the

Use the AUDIO OUT when playing back such

playing back a DVD disc recorded

unit's DIGITAL OUT.

discs.

with 96-kHz, linear PCM audio.

 

 

 

 

 

Sound is distorted or noise is

Disc is dirty.

Wipe the disc surface.

generated.

 

 

 

 

 

Picture does not fit the television

MONITOR TYPE is not correctly set.

Select monitor type correctly. (See page 37.)

screen.

 

 

Television is not correctly set.

Set the television correctly.

 

 

 

 

 

Operation is not possible.

Microcomputer malfunction due to

Turn off the power and unplug the power

 

 

lightning or static electricity.

cord, then connect the power cord again.

 

 

 

 

 

 

Moisture condensation caused by a

Turn off the power, then turn it on a few hours

 

 

sudden change of temperature or

later.

 

 

humidity.

 

 

 

 

 

Additional

information

 

 

44

Image 47
Contents XV-521BK/XV-522SL/XV-523GD Class Laser Product Table of contents Introduction FeaturesSupplied accessories Used for These symbolsOperation can be When you’re away Installation of the unitPower cord Avoid high temperaturesFront panel Preliminary knowledgeNames of parts and controls Audio Strobe button Remote control unitSubtitle Digest button Numeric buttons 10 Infrared signal-emitting windowSubtitle Digest button 23 Audio Strobe button 24Rear panel Display windowPreference displays Operational PrinciplesOn-screen displays Opening displaysStatus displays Play mode displaysTo prevent the monitor from burning out Screen Saver On-screen guide icons How to use numeric buttonsPlayable discs About discsPlayable disc types Disc structureTo connect to a TV Getting startedConnections Before making any connectionsRed White Audio cable not supplied Amplifier or receiver To connect to a TV with the Scart connectorTo connect to an audio amplifier or receiver To connect to audio equipment with a digital input To connect the power cordPrecaution Using the remote control unitTo install batteries in the remote control unit Precautions for the safe use of batteriesManufacturer code list To use the remote control unit for TV operationTo control the volume of a JVC’s amplifier or receiver Setting the remote control signal for operating your TVPress OPEN/CLOSE to close the disc tray Basic operationsTurning on/off the unit Inserting and removing discsTo stop playback temporarily Basic playbackTo start playback To stop playback completelyTo resume playback Resuming playbackTo locate the beginning of the scene or song To memorize the interrupted positionUse Cursor 2/3/5/to select a desired item, then press Enter Advanced operationsTo locate a desired scene from the DVD menu Press Menu or TitleTo locate a desired selection using 4 or ¢ To locate a desired selection using the numeric buttonsMenu Press Play Mode CancelPress Enter Appears underFor DVD Video For Audio CD When you make a mistakeTo locate a desired scene from the digest display Digest Press Audio Strobe while holding down Special picture playbackTo display still pictures Strobe Press PAUSE, then use the Shuttle knob To cancel strobe playTo playback in slow-motion Slow Press SlowUse Cursor 2/3/5/ to move the zoomed-in scene To zoom a scene ZoomTo playback in the desired order Program Press Angle Zoom while holding downUse Cursor 2/3 to move to Random To playback in random order RandomPress Play to start program play Repeat playback To repeat the current selection or all disc contents RepeatBetween a and B For DVD Video For Audio CD To repeat a desired part A-B RepeatTo A-B Repeat Unit locates a and starts repeat playbackScreen Angle Selecting a scene angleTo select a scene angle from the angle list display Angle To change the audio language or sound Audio Changing the language and soundPress 3D Phonic Selecting the picture characterEnjoying virtual surround sound To select the picture character Theater PositionTo check the disc/time information Checking the statusTo turn off the disc/time display Press DISPLAY-TIME To check the DVD function statusPress Display Time while holding down Press Display TimeLanguage Initial settingsHow to set preferences Selecting preferencesAudio Display Auto standby function is off SystemOn-screen guide will be displayed Cursor 2/3 to select the country code Limiting playback by childrenTo set Parental Lock for the first time Points Country Code, useTo change the set level, use Cursor 2/3to To temporarily release the Parental lockPress Enter while holding down Shift To change the country code, use CursorCare and handling of discs Additional informationConnection and setup AV Compu Link remote control systemOperation Symptom Possible case Remedy TroubleshootingSpecifications Appendix a Table of languages and their abbreviations Appendix B Country code list for parental lock Additional information 0500RIMUBNJSC