JVC XV-522SL manual Class Laser Product

Page 2

Warnings, Cautions and Others

IMPORTANT for the U.K.

 

Caution ––

 

button!

 

 

 

 

 

 

 

 

 

 

 

DO NOT cut off the mains plug from this equipment. If the

Disconnect the mains plug to shut the power off

plug fitted is not suitable for the power points in your home

completely. The

 

 

button in any position do not

 

 

or the cable is too short to reach a power point, then obtain

disconnect the mains line.The power can be remote

an appropriate safety approved extension lead or consult

controlled.

 

your dealer.

 

 

 

 

 

 

 

 

 

BE SURE to replace the fuse only with an identical

 

 

 

 

 

 

approved type, as originally fitted.

 

 

 

 

 

 

If nonetheless the mains plug is cut off ensure to remove

 

 

 

 

 

 

the fuse and dispose of the plug immediately, to avoid a

CAUTION

 

 

 

 

possible shock hazard by inadvertent connection to the

To reduce the risk of electrical shocks, fire, etc.:

mains supply.

 

 

1. Do not remove screws, covers or cabinet.

If this product is not supplied fitted with a mains plug then

2. Do not expose this appliance to rain or moisture.

follow the instructions given below:

 

 

 

 

 

 

IMPORTANT.

 

 

 

 

 

 

 

DO NOT make any connection to the terminal which is

 

 

 

 

 

 

marked with the letter E or by the safety earth symbol or

 

 

 

 

 

 

coloured green or green-and-yellow.

Caution: Proper Ventilation

The wires in the mains lead on this product are coloured in

To avoide risk of electric shock and fire and to protect from

accordance with the following code:

Blue :

Neutral

damage.

 

 

 

 

Locate the apparatus as follows:

Brown :

Live

Front:

No obstructions open spacing.

As these colours may not correspond with the coloured

Sides:

No obstructions in 3 cm from the sides.

markings identifying the terminals in your plug proceed as

Top:

No obstructions in 5 cm from the top.

follows:

 

 

Back:

No obstructions in 15 cm from the back

The wire which is coloured blue must be connected to the

Bottom:

No obstructions, place on the level surface.

terminal which is marked with the letter N or coloured black.

 

 

 

 

 

 

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

IF IN DOUBT - CONSULT A COMPETENT ELECTRICIAN.

 

Spacing 15cm or more

 

Front

 

XV-521BK

 

XV-522SL

 

XV-523GD

Wall or

 

obstructions

Stand height

 

5cm or more

 

Floor

IMPORTANT FOR LASER PRODUCTS

REPRODUCTION OF LABELS

1 CLASSIFICATION MARK, PLACED ON REAR NECLOSURE

2 WARNING LABEL, PLACED INSIDE THE UNIT

CLASS 1

LASER PRODUCT

CAUTION: Invisible

laser

radiation when open

and

interlock failed or defeated.

AVOID DIRECT EXPOSURE

TO BEAM.

(e)

 

 

VARNING: Osynlig laser- strålning när denna del är öppnad och spärren är urkopplad. Betrakta ej

strålen.(s)

ADVARSEL: Usynlig laser- stråling ved åbning, når sikkerhedsafbrydere er ude af funktion. Undgå udsæt-

telse for stråling

(d)

VARO: Avattaessa ja suo- jalukitus ohitettaessa olet alttiina näkymättömälle lasersäteilylle. Älä katso

säteeseen. (f)

1.CLASS 1 LASER PRODUCT

2.DANGER: Visible and invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.

3.CAUTION: Do not open the top cover. There are no user service- able parts inside the Unit; leave all servicing to qualified service personnel.

Image 2
Contents XV-521BK/XV-522SL/XV-523GD Class Laser Product Table of contents Introduction FeaturesSupplied accessories Used for These symbolsOperation can be Avoid high temperatures Installation of the unitPower cord When you’re awayFront panel Preliminary knowledgeNames of parts and controls Audio Strobe button Remote control unitSubtitle Digest button Audio Strobe button 24 Infrared signal-emitting windowSubtitle Digest button 23 Numeric buttons 10Display window Rear panelOpening displays Operational PrinciplesOn-screen displays Preference displaysStatus displays Play mode displaysTo prevent the monitor from burning out Screen Saver How to use numeric buttons On-screen guide iconsDisc structure About discsPlayable disc types Playable discsBefore making any connections Getting startedConnections To connect to a TVRed White Audio cable not supplied Amplifier or receiver To connect to a TV with the Scart connectorTo connect to an audio amplifier or receiver To connect the power cord To connect to audio equipment with a digital inputPrecautions for the safe use of batteries Using the remote control unitTo install batteries in the remote control unit PrecautionSetting the remote control signal for operating your TV To use the remote control unit for TV operationTo control the volume of a JVC’s amplifier or receiver Manufacturer code listInserting and removing discs Basic operationsTurning on/off the unit Press OPEN/CLOSE to close the disc trayTo stop playback completely Basic playbackTo start playback To stop playback temporarilyTo memorize the interrupted position Resuming playbackTo locate the beginning of the scene or song To resume playbackPress Menu or Title Advanced operationsTo locate a desired scene from the DVD menu Use Cursor 2/3/5/to select a desired item, then press EnterTo locate a desired selection using the numeric buttons To locate a desired selection using 4 or ¢Appears under Press Play Mode CancelPress Enter MenuFor DVD Video For Audio CD When you make a mistakeTo locate a desired scene from the digest display Digest Press Audio Strobe while holding down Special picture playbackTo display still pictures Strobe Press Slow To cancel strobe playTo playback in slow-motion Slow Press PAUSE, then use the Shuttle knobPress Angle Zoom while holding down To zoom a scene ZoomTo playback in the desired order Program Use Cursor 2/3/5/ to move the zoomed-in sceneUse Cursor 2/3 to move to Random To playback in random order RandomPress Play to start program play To repeat the current selection or all disc contents Repeat Repeat playbackUnit locates a and starts repeat playback To repeat a desired part A-B RepeatTo A-B Repeat Between a and B For DVD Video For Audio CDScreen Angle Selecting a scene angleTo select a scene angle from the angle list display Angle Changing the language and sound To change the audio language or sound AudioTo select the picture character Theater Position Selecting the picture characterEnjoying virtual surround sound Press 3D PhonicChecking the status To check the disc/time informationPress Display Time To check the DVD function statusPress Display Time while holding down To turn off the disc/time display Press DISPLAY-TIMESelecting preferences Initial settingsHow to set preferences LanguageAudio Display Auto standby function is off SystemOn-screen guide will be displayed Points Country Code, use Limiting playback by childrenTo set Parental Lock for the first time Cursor 2/3 to select the country codeTo change the country code, use Cursor To temporarily release the Parental lockPress Enter while holding down Shift To change the set level, use Cursor 2/3toAdditional information Care and handling of discsAV Compu Link remote control system Connection and setupOperation Troubleshooting Symptom Possible case RemedySpecifications Appendix a Table of languages and their abbreviations Appendix B Country code list for parental lock Additional information 0500RIMUBNJSC