JVC XV-N512S manual Important for Laser Products

Page 2

Warnings, Cautions and Others

IMPORTANT for the U.K.

DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer.

BE SURE to replace the fuse only with an identical approved type, as originally fitted.

If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply.

If this product is not supplied fitted with a mains plug then follow the instructions given below:

IMPORTANT.

DO NOT make any connection to the terminal which is marked with the letter E or by the safety earth symbol or coloured green or green-and-yellow.

The wires in the mains lead on this product are coloured in accordance with the following code:

Blue : Neutral

Brown : Live

As these colours may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:

CAUTION

Do not block the ventilation openings or holes.

(If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out).

Do not place any naked flame sources, such as lighted candles, on the apparatus.

When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must be followed strictly.

Do not expose this apparatus to rain, moisture, dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.

Caution: Proper Ventilation

To avoid risk of electric shock and fire and to protect from damage, locate the apparatus as follows:

Front:

No obstructions and open spacing.

Sides:

No obstructions in 3 cm from the sides.

Top:

No obstructions in 5 cm from the top.

Back:

No obstructions in 15 cm from the back.

Bottom:

No obstructions, place on the level surface.

 

Spacing 15 cm or more

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

IF IN DOUBT - CONSULT A COMPETENT ELECTRICIAN.

CAUTION

Wall or

obstructions

XV-N512S

Front

Stand height 5 cm or more

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

Floor

Caution –– STANDBY/ON button!

Disconnect the mains plug to shut the power off completely (the STANDBY/ON lamp goes off).

The STANDBY/ON button in any position does not disconnect the mains line.

When the player is on standby, the STANDBY/ON lamp lights red.

When the player is turned on, the STANDBY/ON lamp lights green.

The power can be remote controlled.

IMPORTANT FOR LASER PRODUCTS

1.CLASS 1 LASER PRODUCT

2.CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel.

3.CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.

4.REPRODUCTION OF LABEL: CAUTION LABEL, PLACED INSIDE THE UNIT.

G-1

Image 2
Contents MP3/WMA and Jpeg discs Changing the initial settingsRegion code of DVD Video Player’s region code is printed on the rear of the playerImportant for Laser Products Table of contents Supplied accessoriesPrecautions About this manualBefore operation About discsFront panel Display window Remote control unitNames of parts and controls Preparations Connecting to a TVConnecting to a TV with the Scart connector ConnectionsConnecting to a TV having composite video input jack Connecting to a TV with an S-video jackSource Connecting to a TV with component jacksProgressive scan video playback available White Red Connecting to optional audio equipmentConnecting to a stereo audio amplifier/receiver Audio cable suppliedConnecting to a digital audio device Digital equipmentTo install batteries Using the remote control unitConnecting the power cord Precautions of the safe use of batteriesOperation To use the remote control unit for TVTo control the volume of a JVC’s amplifier or receiver Operating the TVTurning the player on and off Initial setupBasic playback Press EnterStarting playback Press 5/∞ to select a desired digital output signal typeTo bring up the DVD Player SET UP display later Press 5/∞ to select the desired monitor typeTo check the playback status If a menu is shown on the TV screenAbout PBC Playback Control To stop playback completelyTo resume playback When the resume mode is onWhen the resume mode is Disc Resume To clear the memoryVarious kinds Playback at various speedsPlaying from a specific position Using the numeric buttonsLocating the beginning of a scene or song To locate a desired scene from the DVD menuTo dismiss the menu bar Selecting a still picture on a DVD Audio discTo specify a desired title/group To play back in a specific order Program play Changing the playback orderPlaying back a bonus group of a DVD KEYTo play back in random order Random play To quit A-B repeat playback Repeat playbackTo repeat a desired part A-B repeat playback To change the audio language or sound Audio Changing the language, sound and scene angleTo select the subtitle language Subtitle To select a scene angle of DVD Video AngleTo zoom in pictures To adjust the picture character VFPSpecial picture and sound effects To return to the normal playbackTo dismiss the 3D Phonic window To dismiss the VFP mode selection windowTo simulate surround sound 3D Phonic To bring up the menu bar Basic operation procedureMenu bar functions To dismiss the menu bar and status barTrack Track search Time mode selectionMenu bar functions for DVD Audio CHAP. Chapter searchSubtitle on/off See also Menu bar functions for SVCD/Video CD/ Audio CDPG Original program title search PL Play list search Basic operations VR format disc playbackAbout VR format discs Original playbackTo call up the Original Program display Playback by play listTo start playback of the desired title During playback, press TOP MenuTo repeat title or play list Changing the soundTurning on/off the subtitle To start playback of the desired play listJpeg discs playback PrecautionsMP3/WMA OutlineTo select the start point of the slide show Viewing pictures continuously Slide show modeTo start the slide show To quit repeat playback Press Repeat mode remains activeTo stop repeat playback Selecting preferences Changing the initial settingsHow to set preferences About the Preference displayPicture menu To change the setting, see How to set preferences onLanguage menu You can select the on-screen display language of the playerAudio menu CH., Expert SPK.SETTING menuOthers menu ON, OFF, Disc ResumePreparation To set the delay timeTo set the speaker sizes and the Bass Redirect function To generate test tone signals To set the speaker levelStop mode, bring up the Others menu Limiting playback by childrenTo set Parental Lock for the first time Press 5/∞ to move To select Parental Lock then press EnterTo change the settings To temporarily release the Parental LockAdditional information TroubleshootingPower PictureSpecifications Appendix B Country/Area code list for Parental Lock Appendix C Table of languages and their abbreviationsAppendix D Glossary Above ALL Victor Company of JAPAN, Limited