JVC LVT2013-001A manual Recording Settings, Disc Settings

DRC (Dynamic Range Control)

With the DVD format, you can hear a program’s soundtrack in the most accurate and realistic presen- tation possible, thanks to digital audio technology. However, you may wish to compress the dynamic range of the audio output (the difference between the loudest sounds and the quietest ones). This allows you to listen to a movie at a lower volume without los- ing clarity of sound. Set DRC to [ON] for this effect.

Recording Settings

To access to the General Setting.

1.Press HOME and the Home menu appears.

2.Select [Setup] > [Start] and press ENTER.

3.Use v / V to select (Recording) option and press B.

Disc Record Mode

You can set the picture quality for recording; XP (High Quality), SP (Standard Quality), LP (Low Quality), EP (Extend Quality)

1.Select the [Disc Record Mode] option then press B.

2.Use v / V to select a desired Disc Record Mode (XP, SP, LP or EP).

3.Press ENTER to confirm your selection, then press HOME to exit the menu.

VCR Record Mode

You can set the picture quality for VCR recording; SP (Standard Play), SLP (Super Long Play).

DV Record Audio

You need to set this if you have a camcorder using 32kHz/12-bit sound connected to the front panel DV IN jack. Some digital camcorders have two stereo tracks for audio. One is recorded at the time of shoot- ing; the other is for overdubbing after shooting.

On the Audio 1 setting, the sound that was recorded while shooting is used. On the Audio 2 setting, the overdubbed sound is used.

Auto Chapter

During recording, chapter markers are added auto- matically at fixed intervals. You can set this interval to 5 minutes or 10 minutes. To turn off automatic chap- ter marking, select [None].

Disc Settings

To access to the General Setting.

1.Press HOME and the Home menu appears.

2.Select [Setup] > [Start] and press ENTER.

3.Use v / V to select (Disc) option and press B.

Initialize

If you load a completely blank disc, the recorder will initialize the disc.

•DVD-R: The recorder initialize the disc to Video mode. The recording mode will always be Video mode.

•DVD-RW/DVD+RW/DVD+R/DVD-RAM: The Initialize menu will appears. Select [OK] then press ENTER. DVD-RW disc is initialized to Video mode.

Also, you can reformat the DVD-RW/DVD+RW from the Setup menu as below.

1.Select the [Initialize] option then press B. [Start] icon is highlighted.

2.Press ENTER.

•In case of DVD-RW, use b / B to select a desired Disc Initialize Mode (VR Mode or Video Mode) then press ENTER.

•In case of DVD+RW/DVD-RAM, use b / B to select [OK], and press ENTER.

It takes a few moments to format the disc.

Caution:

If you want to change the disc format, everything recorded on the disc will be erased.

HOOKUP AND SETTINGS

17