Sim2 Multimedia HT300 XTRA-H Switching On And Off The Projector, Switch On From Stand-By

which is undesirable for a large audience.

Preferably, use a screen with black, non-reflecting borders, which will perfectly frame the projected image.

Avoid light shining directly on the screen during projection as this will reduce contrast and black level detail on the projected

image. For the true cinema experience best results are achieved with little or no ambient light.

Furniture and other objects with reflecting surfaces, as well as light coloured walls should be avoided, as they are likely to interfere with the screen’s characteristics.

5 SWITCHING ON AND OFF THE PROJECTOR

CAUTION: Connect the projector to a power supply with a nominal voltage within the following values: 100-240 Vac, 50/60 Hz. It must be earthed (Fig. 13).

Position I : on

Position O : off

Power switch

Fused power socket

Power plug

Fig. 13

Upon switch on (in position I) the projector will initialise (red and green LEDs on). Followed by stand-by mode (red LED on) (Fig. 14).

ne pas

compromettre

pour

d'incende

resque

type

contre les

de meme

ATTENTION:

un

fusible

la

protection

against

par

remplacer

caracteristique

protection

et

de mems

for continued

CAUTION: replace

risk

of fire,

type

R/Cr

with same.

only

fuse

and rating

AUDIO

RGB

G/Y

5 HDMI

OUT

3

ZOOM

4

GRAPHICS

B/Cb

2

(RS

232)

CONTROL

SWITCH ON FROM STAND-BY

By remote control: press one of 1...9

By keyboard: press Up or Down Arrow .

	ZOOM	4	G	R
	2			O
1		CONTR
20
05

F1

E

Fig. 15

When switching on from stand-by, the projector will turn on the lamp; after a brief warm up period the image will be displayed (green LED on).The input automatically selected will be the last one memorised prior to switch off (Fig. 15).

You may experience difficulties switching on the projector shortly after switching off: the lamp may fail to come on as it is too hot. Just wait a few minutes to cool it down.

HV

Fig. 14

9