JVC PD-42X795 manual Key Feature Buttons, Basic Operation, Remote Control

Quick Setup Getting Started

Step 2 – The Remote Control

Before you can operate your remote control, you first need to install the batteries (included).

Slide the cover on the back of the remote down towards the bottom of the remote control. Insert two batteries (included) carefully noting the “+” and “–” markings, placing the “–” end in the unit first. Slide the cover back into place.

When you change the batteries, try to complete the task within three minutes. If you take longer than three minutes, the remote control codes for your VCR, DVD, and/or cable box/satellite receiver may have to be reset. See pages 33 - 36.

Key Feature Buttons
The four key feature buttons at the center	of the remote can be
used for basic operation of the television. The top and bottom		MUTING				GUIDE
buttons will scan forward and back through the available				CH
channels. To move rapidly through the channels using
JVC’s Hyperscan feature, press and hold CH+ or CH–. The			VOL	OK	VOL
channels will zip by at a rate of five channels per second. The
right and left buttons will turn the volume up or down. These				CH
buttons are also marked with four arrows and are used with
JVC’s onscreen menu system. To use the onscreen menus,		MENU				BACK
press the MENU button.

Basic Operation		POWER
		T
Turn the television on and off by pressing the POWER button at the top right corner
of the remote. If this is the first time you are turning on the TV, the interactive
		TV CATV
plug-in menu appears.
•	Make sure the TV/CATV switch is set to TV. Move the switch to CATV only if
	you need to operate a cable box.
		MU
•	Slide the VCR/DVD selector switch to VCR to control a VCR. Slide to DVD to	VCR DVD
	control a DVD player. Please see pages 33 - 36 for instructions on programming
	your remote control to operate a cable box, VCR or DVD player.

15