JVC PD-42X795 manual Connecting to a Digital TV Receiver, DTV Decoder Hdmi to DVI Cable

Quick Setup Connections

Connecting to a Digital TV Receiver

By connecting a Digital TV Receiver, high definition pictures can be displayed on your TV in their digital form.

DIGITAL OUT

AUDIO OUT

L R

DTV Decoder

HDMI to DVI Cable

VIDEO	AUDIO						CENTER
							CHANNEL
DIGITAL	DIGITAL		ATSC/	R		L	INPUT
			DIGITAL CABLE IN	DVI
				ANALOG
				AUDIO
				IN
				Pr		Pb	Y
				INPUT2
HDMI		AV COMPULINK
				R	AUDIO	L	VIDEO

Receiver Rear Panel

After the connections have been made, tighten the screw to secure the cables.

1)Connect the HDMI to DVI Cable from the DIGITAL OUT on the back of your DTV decoder, to the DIGITAL-IN on the back of your receiver.

2)Connect a red cable from the DTV decoder RIGHT AUDIO OUT, to the RIGHT AUDIO DIGITAL-IN on the back of your receiver.

3)Connect a white cable from the DTV decoder LEFT AUDIO OUT, to the LEFT AUDIO DIGITAL-IN on the back of your receiver.

•The digital-in terminal is not compatible with the picture signal of a personal computer.

•Use a HDMI to DVI cable (commercially available) in order to digitally connect the television with a DTV decoder.

Notes:

•If 480p signals (640x480 or 720x480) are displayed on the screen, the horizontal balance may be slightly shifted. Access the “DIGITAL-IN” in the initial setup menu to adjust it. (Refer to page 56.)

•When you do the above connection, set DIGITAL-IN AUDIO in the Initial Setup menu to ANALOG. See "DIGITAL-IN AUDIO", page 57.

26