JVC LV42740-001A Only for Dolby Digital DVD Video Discs, Output Playback discs, Lt/Rt, L0/R0

Page 63
OFF
OFF
OFF
OFF
MODE1
DVD1
DIGITAL AUDIO OUTPUT DOWN MIX COMPRESSION
DTS BASS MANAGEMENT AUTO STANDBY SCREEN SAVER
AV COMPULINK MODE
PRESS KEY
STREAM/PCM
PREFERENCE1 PREFERENCE2 SPK. SETTING

Initial settings

•STREAM/PCM

Should be selected when you connect to the digital input of an amplifier with a built-in DTS, Dolby Digital, or MPEG multichannel decoder.

•DOLBY DIGITAL/PCM

Should be selected when you connect to the digital input of a Dolby Digital decoder, or an amplifier with a built-in Dolby Digital decoder.

The following chart shows the relationship between types of playback discs and output signals.

 

Output

 

 

 

 

 

 

Playback discs

STREAM/

DOLBY

 

 

DIGITAL/

PCM ONLY

 

PCM

 

PCM

 

 

 

 

 

 

 

 

DVD with 48/44.1

48/44.1 kHz,

 

 

kHz, 16 bit linear

16 bit, stereo

+

+

PCM

linear PCM

 

 

 

 

 

 

DVD with 48/44.1

48/44.1 kHz,

 

 

kHz, 20/24 bit

16 bit, stereo

+

+

linear PCM

linear PCM*

 

 

 

 

 

 

DVD with 96/88.2

No output

+

+

kHz, linear PCM

 

 

 

 

 

 

 

 

DVD with 192/

No output

 

 

176.4 kHz, 16/22/

 

+

+

24 bit linear PCM

 

 

 

 

 

 

DVD with DTS

DTS bitstream 48 kHz, 16 bit,

 

 

 

stereo linear

+

 

 

PCM*

 

 

 

 

 

DVD with Dolby

Dolby Digital

 

48 kHz, 16 bit,

Digital

bitstream

+

stereo linear

 

 

 

PCM*

 

 

 

 

Video CD

44.1 kHz,

 

 

 

16 bit, stereo

+

+

 

linear PCM

 

 

 

 

 

 

Audio CD

44.1 kHz,16

 

 

 

bit,

+

+

 

stereo linear

 

 

 

 

PCM

 

 

DOWN MIX

To playback a DVD VIDEO

disc recorded with surround multichannel audio correctly, the DOWN MIX setting must be properly made according to

your audio system.

Note that this setting affects

only the output signal from the ANALOG AUDIO output jacks when playing back a DVD VIDEO disc recorded with surround multichannel audio.

•Lt/Rt

Should be selected when you enjoy multichannel surround audio by connecting the unit’s ANALOG AUDIO output to a surround decoder.

•L0/R0

Should be selected when you enjoy conventional 2- channel stereo audio by connecting the unit’s AUDIO output to a stereo amplifier/receiver or television set, or when you duplicate audio of a DVD VIDEO disc recorded with surround audio to your MD, cassette, etc.

•OFF

When you enjoy multichannel surround audio by connecting the unit's 5.1-channel audio outputs to an amplifier equipped with 5.1-channel inputs.

NOTES

•The “DOWN MIX” function does not work when the 3D PHONIC function is activated.

•Some DVD AUDIO discs prohibit the 2-channel down- mix. For such a disc, you cannot get the down-mixed signal even if you set “DOWN MIX” to “Lt/Rt” or “Lo/ Ro”.

COMPRESSION

(only for Dolby Digital DVD VIDEO Discs)

Initial settings

Audio CD with DTS

DTS bitstream 44.1 kHz,

 

 

 

16 bit, stereo

+

 

 

linear PCM

 

 

 

 

 

CD-R with MP3

No output

+

+

*With some DVD VIDEO discs that are not fully copy- protected, a 20 or 24 bit digital signal may be output.

When enjoying a DVD VIDEO disc recorded with the Dolby Digital format at low or middle volume, setting COMPRESSION to ON makes you hear sound comfortably.

•ON

PREFERENCE1

PREFERENCE2

SPK. SETTING

DIGITAL AUDIO OUTPUT

STREAM/PCM

DOWN MIX

 

 

OFF

COMPRESSION

 

OFF

DTS BASS MANAGEMENT

 

OFF

AUTO STANDBY

 

OFF

SCREEN SAVER

 

MODE1

AV COMPULINK MODE

 

DVD1

PRESS

KEY

 

 

NOTE

•When playing a DVD VIDEO or Audio CD disc with DTS, use a DTS decoder to get correct signals from your speakers.

Audio is played back with the dynamic range compressed.

•OFF

Audio is played back as it was recorded.

NOTES

•The “COMPRESSION” function works only when playing back a disc recorded with DOLBY DIGITAL. The setting is not effective for other discs.

•The “COMPRESSION” function does not work when the 3D PHONIC function is activated.

60

Page 62 Page 64
Image 63
Page 62 Page 64
Contents English $%.9$ Mises en garde, précautions et indications diverses Table of Contents DTS Digital Theater Systems FeaturesIntroduction Linear PCMAV compulink cable x Supplied accessoriesTo select a scene angle from the angle list display Angle Press and hold Angle for more than 1 second¶ During DVD Video playback Important cautions Safety precautionsPreliminary knowledge Names of parts and controlsFront panel Display window Remote control unit Clear button 29, 40 @ Infrared signal-emitting windowTV/VIDEO Cancel button 24 Previous button 29, 35Rear panel Opening display Operational PrinciplesOn-screen displays Basic operations of on-screen displaysParental Lock display see DVD Control for DVD Video displayDVD Control for DVD Audio display MP3 Control display see To prevent the monitor from burning out Screen SaverCD Control display VCD Control displayOn-screen guide icons How to use numeric buttonsPlayable discs About discsPlayable disc types Audio formatsDisc structure To connect to a conventional TV Getting startedConnections Before making any connectionsWhite How to make the Progressive scan mode activeTo connect to a TV with the component video input jacks Blue Green Red UnitAbout Scan Mode To connect to an audio amplifier or receiverRed White Audio cable Supplied Amplifier or receiver Supplied Amplifier or receiver Optical digital cable not supplied To connect to audio equipment with a digital inputUsing the remote control unit To connect the power cordTo install batteries in the remote control unit Precautions for the safe use of batteries PrecautionRemote sensor Manufacturer code list To use the remote control unit for TV operationSetting the remote control signal for operating your TV You can operate your TV from the remote control unit+10 Press0 OPEN/CLOSE on the front panel Basic operationsTurning on/off the unit Inserting and removing discsPlace it in the inner recess Place one or two discs in the traysWith the label side up To insert an 8-cm discAbout Disc indicators 1 through Basic playbackTo start playback To advance or reverse playback rapidly while monitoring Method 1 from the remote control unit onlyTo stop playback completely To stop playback temporarilyPress EXCHANGE/ Disc Skip To locate the beginning of the scene or songChanging discs during playback Play Exchange Press 4 or ¢Resuming playback To memorize the interrupted positionTo resume playback Playing from a specific position on a disc Advanced operationsFunction Audio VideoExample To locate a desired scene from the DVD menuPress TOP Menu or Menu Use the numeric buttons to select the desired itemFor an Audio CD or Video CD, a track is Specified Unit status Disc type What is SpecifiedWhen appears on the TV screen Use the numeric buttons to specify the numberMessage area For DVD Audio To locate a desired selection using 4 or ¢Press on Screen Press EnterUse Cursor 5/∞ to move to Time SEARCH, then press Enter Use the numeric buttons 0 to 9 to enter the timeScreen example Unit starts playback from the selected scene When you make a mistakeTo locate a desired scene from the display Digest Use Cursor 5/∞/2/3 to move to select the desired scenePress and hold 8 for more than 1 second To cancel strobe playSpecial picture playback To display continuous still pictures Strobe¶ During playback or while paused Use Cursor 5/∞/2/3 to move the zoomed English positionPress Zoom + or To return to normal playback Press EnterUse Cursor 5/∞ to move to Program and press Enter Changing the playback orderTo playback in the desired order Program 3a for Audio CD/Video CDTo quit random playback in the middle To playback in random order RandomTo quit program playback For Video CD For Audio CDDuring DVD Video playback Repeat playbackTo repeat the current selection or all tracks Repeat Press RepeatTo stop repeat playback Press Selected repeat mode For Video CDAudio CD/Video CD Disc type Display window On-screen displayPress Angle Selecting a scene angleTo select a scene angle from the normal screen Angle From normal screenTotal number of recorded angles From on-screen displayUse Cursor 5/∞ or Angle to move to Angle Use Cursor 2/3 or Angle to select the desired angle numberChanging the language and sound To select the subtitle language SubtitleFrom on-screen display DVD Video only Use Audio S.FREQ or Cursor 2/3 to select the desired audio To change the audio language or sound AudioUse Cursor 5/∞ or Audio S.FREQ to move to Audio Press Audio S.FREQMiscellaneous functions To adjust the picture character VFPPress VFP Progressive Scan to select the desired preset Selected presetPress 3D Phonic Adjust the level of the parameter using Cursor 2/3Select the desired mode by using 3D Phonic Selected effect modePress Cursor 2/3 to adjust the effect level Use Cursor 5/∞ to move to Time SelectDuring playback for DVD AUDIO/Audio CD Use Cursor 2/3 or page to select the desired To select a still picture on a DVD Audio discFrom normal display Use Cursor 5/∞ or page to move toDisplay Window TV screen ¶ When no disc is insertedTo playback a bonus group of a DVD Audio disc Press Cursor 5 or ∞ while holding downPress Audio S.FREQ for more than one second Checking the sampling frequencyBasic operations MP3 disc playbackAbout MP3 disc OperationsTrack time Highlight a desired Group using Cursor Press EnterHighlight a desired Track using Cursor Specifying the desired Group and Track¶ During playback or while stopped You cannot repeat all contents on discRepeat playback You can repeat playback of the current track or groupLanguage and display preference Initial settingsHow to set preferences Selecting preferencesCharacters on the picture Setting changes as followsWhich show what is Unit can display on Screen guide icons orAudio and system preference L0/R0 Only for Dolby Digital DVD Video DiscsOutput Playback discs Lt/RtMode This item controls Output signals when playingBack DTS-encoded DVD Video discsSpeaker size settings Available only when selecting Expert Speaker settingSpeaker Channel setting Bass redirect Available only when selecting ExpertDelay Available only when selecting Expert Test tone Available only while setting Level orTo set Parental Lock for the first time Limiting playback by childrenScreen display appears To change the settingsPoints Password To change the set level, use Cursor 2/3 toUse the Cursor 5/∞ to move to YES, then press Enter Enter your 4-digit password using the numeric buttons 0 toTo AV Compu Link II or EX DVD player AV Compu Link remote control systemConnection and setup Additional informationTurn on the main power of the television OperationYou connect the component video output to your TV Label side How to handle discsMaintenance of discs Care and handling of discsSymptom Possible case Remedy TroubleshootingSpecifications Appendix ATable of languages and their abbreviations Appendix BCountry code list for Parental Lock Authorized Service Centers Limited Warranty JVC 0801YMZDTEJEM
Top Page Image Contents