Runco LS-7 operation manual op operation command CR, Precede operation and command with a space

Serial Communications

Table 6-1. Serial Command Key Names and IR Codes (continued)

RS232	Remote Button	IR Code		Description
Keyname
		Set 1	Set 2
asp.16.9	(none)	0x9E	0xDE	Apply 16:9 aspect ratio to the active
				source.
asp.4.3	(none)	0x9F	0xDF	Apply 4:3 aspect ratio to the active source.
asp.lett	(none)	0xA0	0xE0	Apply Letterbox aspect ratio to the active
				source.
asp.narr	(none)	0xA1	0xE1	Apply 4:3 Narrow aspect ratio to the active
				source.
pip.sw		0xA3	0xE3	Switch to next “PIP Select” state.
	PIP
pip.1	(none)	0xA4	0xE4	Change “PIP Select” to source 1.
pip.2	(none)	0xA5	0xE5	Change “PIP Select” to source 2.
pip.3	(none)	0xA6	0xE6	Change “PIP Select” to source 3.
pip.4	(none)	0xA7	0xE7	Change “PIP Select” to source 4.
pip.5	(none)	0xA8	0xE8	Change “PIP Select” to source 5.
pip.off	(none)	0xA9	0xE9	Change “PIP Select” to off.
pip.swap	SWAP	0xAA	0xEA	Swap the PIP image with the active source
				image.
pow.tog	(none)	0xAC	0xEC	Toggles between power on and power off.
lit.tog	LIGHT	0xAD	0xED	Activates remote backlighting only when
				pressed momentarily. When held for five
				seconds or more, the IR code for toggling
				the projector I/O panel light is transmitted.

Operations Commands ➤ Operations commands allow more flexible and direct control of the projector. The syntax for operations commands is as follows:

op <operation> <command>[CR]

(Precede <operation> and <command> with a space.)

The command type can be one of 5 functions:

Operations Control Commands

Function	Command	Action on unit
Set	= <value>	Makes the unit take that value.
Get	?	Asks what the current value is.
Increment	+	Adds 1 to the current value.

68 Runco LS-7 Installation/Operation Manual