Contents |
|
For your safety | 1 |
Important Information | 4 |
Remote Control Buttons | 5 |
Control Panel Buttons | 6 |
Using the stand | 7 |
How to remove the stand | 7 |
Installing TV on the wall | 8 |
Preparation | 9 |
Before Switching on your TV | 9 |
Switching the TV ON/OFF | 10 |
Initial Settings | 11 |
Operating the TV | 12 |
Menu System | 13 |
Other Features | 19 |
PC Mode | 21 |
Teletext | 23 |
Peripheral Equipment Connections | 24 |
Peripheral Equipment Connections | 26 |
Antenna Connections | 27 |
Peripheral Equipment Connections | 27 |
PC Input Typical Display Modes | 28 |
Tips | 29 |
Specifications | 30 |
For your safety
This equipment has been designed and manufactured to meet international safety stan- dards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. So, please read the points below for your own safety. They are of a general nature, intended to help you with all your electronic consumer products and some points may not apply to the goods you have just purchased.
Some “DOs” and “DON’Ts” for you
Air Circulation…
Leave at least 10cm clearance around the tele- vision to allow adequate ventilation. This will prevent the TV from overheating and conse- quential possible damage to the TV. Dusty places should also be avoided.
Heat Damage…
Damage may occur if you leave the TV in di- rect sunlight or near a heater. Avoid places subject to extremely high temperatures or hu- midity, or locations where the temperature is likely to fall below 5ºC (41ºF).
Mains Supply…
The mains supply required for this equipment is
Hot / Moderate Climate Conditions
This device is suitable for working in hot and moderate climate conditions.