Kramer Electronics user manual Connecting the TP-141, TP-142

Page 13

8.If required, On the TP-142:

Set the XGA/VIDEO switch to XGA

With a small screwdriver, adjust the video output signal level and/or cable compensation equalization level

Set the H SYNC and V SYNC switches, on the underside

By default, both switches are set to the left (for negative V SYNC and H SYNC polarity)

Figure 3: Connecting the TP-141, TP-142

10	TP-141, TP-142 - Connecting the TP-141, TP-142

Image 13

Contents TP-141 Page Figures Introduction Achieving the Best Performance Getting StartedRecycling Kramer Products Safety InstructionsOverview About the Power Connect FeatureShielded Twisted Pair STP/Unshielded Twisted Pair UTP Defining the TP-141 XGA/Audio Line Transmitter Feature FunctionTP-142 XGA/Audio Line Receiver Defining the TP-142 XGA/Audio Line ReceiverLink LED Power and then switch on the power to each device Connecting the TP-141, TP-142Connecting the TP-141, TP-142 PIN Wiring the TP Line in / Line OUT RJ-45 ConnectorsTP-141 TP-142 Technical SpecificationsPage Safety Warning