Kramer Electronics TP-141 user manual Overview, About the Power Connect Feature

Page 7

3 Overview

The TP-141and TP-142are a high-immunity, extended-range twisted pair transmitter and receiver for computer graphics video and unbalanced stereo audio signals.

The TP-141converts computer graphics video and audio inputs to twisted pair signals, and the TP-142converts the twisted pair signals back into computer graphics video, unbalanced stereo and S/PDIF digital audio signals. Together the TP-141and TP-142form a computer graphics video/audio line transmitter/receiver system.

More specifically, the products feature:

∙Highest immunity from any kind of interference

∙Resolution up to UXGA

∙HDTV compatibility

∙Simultaneous unbalanced stereo and S/PDIF (24-bit 48kHz) audio outputs (TP-142)

∙Level (gain) and EQ (peaking) controls (TP-142)

∙System range up to 250m (750ft)

∙Power Connect™ System - Only one unit in a system, the transmitter or the receiver, needs to be connected to a power source when the devices are within 50m (150ft) of each other

Note: The TP-141and TP-142are not compatible with existing Kramer TP units such as the TP-121, TP-122, and so on.

3.1About the Power Connect™ Feature

The Power Connect feature applies as long as the cable can carry power. This feature is available when using STP cable and the distance does not exceed 50m (164ft) on standard CAT 5 cable. For longer distances, heavier gauge cable should be used (TP cable is still suitable for the video/audio transmission, but not for feeding the power at these distances). For units which are connected via RJ-45

4

TP-141, TP-142 - Overview

 

 

Page 6 Page 8
Image 7
Page 6 Page 8
Contents TP-141 Page Figures Introduction Achieving the Best Performance Getting StartedRecycling Kramer Products Safety InstructionsOverview About the Power Connect FeatureShielded Twisted Pair STP/Unshielded Twisted Pair UTP Defining the TP-141 XGA/Audio Line Transmitter Feature FunctionTP-142 XGA/Audio Line Receiver Defining the TP-142 XGA/Audio Line ReceiverLink LED Power and then switch on the power to each device Connecting the TP-141, TP-142Connecting the TP-141, TP-142 PIN Wiring the TP Line in / Line OUT RJ-45 ConnectorsTP-141 TP-142 Technical SpecificationsPage Safety Warning
Top Page Image Contents