Hitachi 65S700, 57S700, 51S700 Manual Convergence Adjustment Mode, To Move Adjustment Point

SETUP

Manual Convergence Adjustment Mode

NOTES: 1, Please turn ON your television for at least 20 minutes before using this feature.

2.Auto Adjustment Mode is recommended. If convergence is still not acceptable, use the Manual Adjustment Mode. DO NOT press MAGIC FOCUS or use Auto Adjustment Mode after using Manual Adjustment Mode.

Using the Remote Control, select SETUP-MAGIC FOCUS TUNE UP-MANUAL ADJUSTMENT MODE-START to access convergence crosshatch pattern. The adjustment point is indicated by the Adjustment Point Cursor.

To Move Adjustment Point

To move the adjustment point cursor using the THUMBSTICK, the Adjustment Cursor must be WHITE. Another way to move the Adjustment Point Cursor is to press the following buttons: [2] up, [4] left, [5] down, [6] right. If you use the number buttons while the adjustment point is WHITE, it will change to RED,

To Change the Color of Adjustment Point
Press the SELECT button repeatedly (WHITE-RED-BLUE-WHITE...).	Green color is fixed and cannot be adjusted.

To Adjust the Convergence

Move the Adjustment Cursor to the point to be adjusted. Use the THUMB STICK to match the RED and BLUE colors to GREEN (reference color). Properly aligned, all three colors should appear white.

A_pe_tI

(:hart Manag_= ¸ I

Lock'_I

_w _ SeE I

Se_Lq>

f, Hgrl_ _f_ _e(_, G_,eem and _Eue

If convergence is acceptable after Manual Convergence

I _er_LJ _,r_,f_r_nce

T_OMBTHUrCB

STICKSTICK

THUrCB
STICK
©.	Adjustment	Point

/Cursor

/

/

THUM_T_4'_MB

8T_OKSTICK

adjustment, press EXIT button to access menu mode.

		P_ease			Enter		Numbt._
		0	Cancel		and		go	to Normal		_ode
		1	Done		and	go	to		Nor_a_	_1ode
_	i	2	[	ack	to	Adjust			_ode
		117		_anua_		Ac_iust
		3	Factory			_tc%ot		and
									Back to	Adju=,l=	_ode
		0	3	Select

Press the [0] button on the remote control to CANCEL adjusted data and return to main picture. Press the [1] button on the remote control to SAVE adjusted data and return to main picture,

Press the [2] button on the remote control to return to the manual convergence adjustment mode (crosshatch pattern). Press the [3] button on the remote control to recall the factory pre-set convergence data.

Press the [9] button on the remote control to read the SAVED adjusted data. If there is no saved data, pressing the [9] button will recall the factory pre_set data.

64