NEC X552SAVT Power Indicator, Using Power Management, Selecting a video source, Picture Aspect

Power Indicator

Mode	Status Indicator Light
Power ON	Green*1
Power OFF	Red
Power consumption under 0.5 W
Power Save	Amber
Power consumption under 1 W*2
Power Standby when “SCHEDULE	Green and Amber blink alternately
SETTINGS” enabled
Diagnosis (Detecting failure)	Red Blinking
	(See Troubleshooting page 39)

*1 If “OFF” is selected in POWER INDICATOR (page 25), the LED will not light when the LCD monitor is in active mode.

*2 Without any option, with factory settings, VGA input only.

Using Power Management

The LCD monitor follows the VESA approved DPM Display Power Management function.

The power management function is an energy saving function that automatically reduces the power consumption of the display when the keyboard or the mouse has not been used for a fi xed period.

The power management feature on your new display has been set to the “ON” mode. This allows your display to enter a Power Saving Mode when no signal is applied. This could potentially increase the life and decrease the power consumption of the display.

NOTE: Depending on the PC and video card used, this function may not operate.

NOTE: It takes about 10 minutes for the monitor to go into power management mode when using DVD/HD, SCART, VIDEO1, VIDEO2 and S-VIDEO.

Selecting a video source

To view a video source:

Use the input button to set [VIDEO1], [VIDEO2], [S-VIDEO].

Use the COLOR SYSTEM menu to set [AUTO], [NTSC], [PAL], [SECAM], [PAL60], [4.43NTSC], according to your video format.

Picture Aspect

DVI, VGA, DPORT

FULL 1:1 ZOOM NORMAL

HDMI, DVD/HD, SCART, VIDEO1, VIDEO2, S-VIDEO

FULL WIDE DYNAMIC 1:1 ZOOM NORMAL

Aspect ratio	Unchanged view*3	Recommended selection
of image		for picture aspect*3
		NORMAL

4:3

DYNAMIC

FULL

Squeeze

WIDE

Letterbox

*3 Grey areas indicate unused portions of the screen.

NORMAL: Displays the aspect ratio the same as it is sent from the source.

FULL: Fills entire screen.

WIDE: Expands a 16:9 letter box signal to fi ll entire screen.

DYNAMIC: Expands a 4:3 pictures to fi ll the entire screen with non-linearity. Some of the outside image area will be cut off due to expansion.

1:1: Displays the image in a 1 by 1 pixel format.

ZOOM

The image can be expanded beyond the active display area. The image which is outside of active display area is not shown.

ZOOM

ZOOM

English

English-19