NEC X552SAVT Installation, Mounting, Please note the following when mounting on wall or ceiling

10-12 mm

under

￿ 8.5 mm

Installation

English

This device cannot be used or installed without the Tabletop Stand or other mounting accessory for support. For proper installation it is strongly recommended to use a trained, NEC authorized service person. Failure to follow NEC standard mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation. Failure to follow these recommendations could result in voiding the warranty.

Mounting

DO NOT mount the monitor yourself. Please ask dealer. For proper installation it is strongly recommended to use a trained, qualifi ed technician. Please inspect the location where the unit is to be mounted. Mounting on wall or ceiling is the customer’s responsibility. Not all walls or ceilings are capable of supporting the weight of the unit. Product warranty does not cover damage caused by improper installation, remodelling, or natural disasters. Failure to comply with these recommendations could result in voiding the warranty.

DO NOT block ventilated openings with mounting accessories or other accessories.

For NEC Qualified Personnel:

To ensure safe installation, use two or more brackets to mount the unit. Mount the unit to at least two points on the installation location.

Using an optional wall mount

•When using an optional wall mount, stand holders may need to be taken out. See diagram below:

Optional Stand holder

If mounting accessory is interfered with stand holder, it may need to be taken out also.

•When using an optional wall mount (WM-46S-L/ WM-46S-P)* or there is not enough room in back side, the handles may need to be changed from normal to thin position. See diagram below:

*: Except for X401S

(X401S)

Please note the following when mounting on wall or ceiling

•When using mounting accessories other than those that are NEC approved, they must comply with the VESA- compatible (FDMlv1) mounting method.

Normal position

•NEC strongly recommends using size M6 screws

(10-12 mm + thickness of bracket and washers in length). If using screws longer than 10-12 mm, check the depth of the hole. (Recommended Fasten Force: 470 - 635N•cm) NEC recommends mounting interfaces that comply with UL1678 standard in North America.

Unit No gap	Mounting
	Bracket
No thread	Washers
4 mm
	Screw

Thickness of bracket and washers

Screw length should equal depth of hole (10-12 mm) + the thickness of mounting bracket and washers. Bracket hole should be under ￿ 8.5 mm.

	Thin position
(X462S/X552S)
Screw position	Normal position
change

•Prior to mounting, inspect the installation location to insure that it is strong enough to support the weight of the unit so that the unit will be safe from harm.

•Refer to the instructions included with the mounting equipment for detailed information.

•Make sure there is no gap between the monitor and the bracket.

Thin position

English-5