Connections | Always turn off the power supply of the computer and the |
monitor before performing the connection procedures. |
The connection method differs depending on the type of computer the monitor is connected to.
Refer to the following page to connect the monitor.
When other types of computers are used, refer to their operation manual for the correct connection procedures.
Connection Preparation
Cable storage compartment cover
Connect the signal cable and electrical cord and then store the cable section that is not used in this compartment.
Refer to the following figure in advance and remove the cover of the cable storage compartment. (Remove the cover while pressing the parts indicated by the eand f arrow marks in the figure.)
Signal cable Connection
Connection method will differ in accordance with the computer in use. Connect one end of the supplied signal cable to the mini
Tighten the screws securing the plug tightly to prevent it from becoming disconnected.
Connect the standard connector to the video input connector on the rear side of the monitor.
Place the signal cable to the hook on the rear side of the monitor.
■To an IBM PC or Compatible
■To a Macintosh
Connect the standard connector to the video output connector of the computer.
Tighten the screws securing the plug tightly to prevent it from becoming disconnected.
Use the accessory signal cable and the adapter for the Macintosh. Connect the cable as shown in the figure. When another video card is used, read the operation manual for that card.
| Connect the Macintosh |
| adapter to the computer |
| video output connector. |
Macintosh | Connect the signal |
adapter | connector to the |
(not included) | Macintosh adapter. |
Tighten the screws on the connector or adapter securely.
I - 7