AC Power Cord | Always use the power supply cord that is enclosed with |
the unit. |
If the enclosed power supply cord is not used, use a power cord that conforms to the following regional standards.
U.S.A | UL | Switzerland | SEV |
Canada | CSA | Britain | BASEC / BS |
Germany | VDE |
|
|
In other regions, for safety please use an AC plug cord that complies with each country’s safety regulations.
Power Cord Connection | Always use the accessory power cord and be sure to |
connect the ground line. |
1Use the accessory AC power cord.
2Connect the AC plug (female pins) to the main unit.
3Connect the AC plug (male pins) to the electrical outlet. Caution: Always connect the ground wire.
4Attach the cord compartment cover.
| 4 |
3 | 2 |
| |
| 1 |
Turn on the Power
Figure 2 | Figure 1 |
Place the monitor where it will be used.
Use a power source that supplies AC 100 V - 240 V at 50 Hz / 60 Hz. Turn on the power switch of the display panel (Figure 1: Press the switch continuously until the pilot LED lights.) and then turn on the computer power switch (Figure 2).
** Refer to the section “Operation Procedures” on page
I - 10