FCC Information
1.Use the attached specified cables with this equipment so as not to interfere with radio and television reception.
(1)The power supply cord you use must have been approved by and comply with the safety standards of U.S.A.
(2)Please use the supplied shielded video signal cable. Use of other cables and adapters may cause interference with radio and television reception.
(3)Please attach the ferrite cores on the Audio Cable. please see page 13 of this manual.
2.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult your dealer or an experienced radio/TV technician for help.
If necessary, the user should contact the dealer or an experienced radio/television technician for additional sug- gestions. The user may find the following booklet, prepared by the Federal Communications Commission, helpful: “How to Identify and Resolve
Declaration of Conformity
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
U.S. Responsible Party: | NEC Display Solutions of America, Inc. |
Address: | 500 Park Blvd, Suite 1100 |
| Itasca, Illinois 60143 |
Tel. No.: | (630) |
|
|
Type of Product: | Computer Monitor |
Equipment Classification: | Class B Peripheral |
Model: | Multeos M40 (L406T3) |
| Multeos M46 (L466T4) |
We hereby declare that the equipment specified above conforms
to the technical standards as specified in the FCC Rules
付困
っ
た
録と
き
64