NEC 500, 700, 700M, 900 manual Canadian Department of Communications Compliance Statement

Page 3

WARNING

TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT'S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED.

REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

CAUTION

RISK OF ELECTRIC SHOCK ¥ DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This symbol warns user that uninsulated voltage within the unit may have sufficient magnitude to cause electric shock. Therefore, it is dangerous to make any kind of contact with any part inside this unit.

This symbol alerts the user that important literature concerning the operation and maintenance of this unit has been included. Therefore, it should be read carefully in order to avoid any problems.

Canadian Department of Communications Compliance Statement

DOC: This Class B digital apparatus meets all requirements of the Canadian Interference- Causing Equipment Regulations.

C-UL: Bears the C-UL Mark and is in compliance with Canadian Safety Regulations according to CAN/CSA C22.2 No.950

FCC Information

1.Use the attached specified cables with the AccuSync color monitor so as not to interfere with radio and television reception.

(1)Please use the supplied power cable or equivalent to ensure FCC compliance.

(2)Please use the supplied shielded video signal cable.

Use of other cables and adapters may cause interference with radio and television reception.

2.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment gener- ates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

¥ Reorient or relocate the receiving antenna.

¥ Increase the separation between the equipment and receiver.

¥ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

¥ Consult your dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the userÕs authority to operate the equipment.

If necessary, the user should contact the dealer or an experienced radio/television technician for additional suggestions. The user may find the following booklet, prepared by the Federal Communications Commission, helpful: ÓHow to Identify and Resolve Radio-TV Interference Problems.Ò This booklet is available from the U.S. Government Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.

1

AS500700700M900FINAL2.p65

1

11/11/03, 1:45 PM

Page 2 Page 4
Image 3
Page 2 Page 4
Contents AccuSyncTM 500/700/700M/900 Index Canadian Department of Communications Compliance Statement Contents Connecting the Tilt/Swivel stand Quick StartRemoving the Tilt/Swivel stand Figure A.1 Pin mini D-SUB Captive Signal Cable Figure C.1 Power Outlet Power Cord Control Direct Access Function Controls AccuSyncControlFunction Controls AccuSync 700/900 Function Direct Access FunctionControls AccuSync 700M ControlSide Jacks Rear Panel JacksMicrophone Operation Controls Screen AdjustmentPosition Size To adjust the size of the screenTilt To adjust the shape of the screen Side Pincushion Reset Moire AdjustableGeometry Green Blue Video Level PresetTemp REDMoire ResetMain Menu ACCUSYNCª Color Monitor Recommended UseAdjust the monitor height so that the top ≤ 15W DPM Off Specifications AccuSyncPower Normal 63W Consumption Plug & PlayDepth 420 mm / 16.5 inches Specifications AccuSyncPower Normal 73W Consumption ≤ 15WSpecifications AccuSync 700M Inches 18.0 inches viewable Features No picture TroubleshootingReferences NEC-Mitsubishi Monitor Customer Service & SupportLimited Warranty Declaration of the Manufacturer Avertissement La bote de votre nouveau moniteur NEC AccuSyncMC contient ContenuMise en marche rapide Raccorder Socle Inclinable/RotatifDŽposŽe Socle Inclinable/Rotatif Remarque Mise en marche rapide -suiteMise en marche rapide -suite Dpms Commandes AccuSyncCommande Fonction CommandeCommandes -suite AccuSync 700/900 Commande Fonction à accès direct Commandes -suite AccuSync 700MPrises latérales Prises du panneau arrièreLine OUT Réglage de laffichage Commandes -suiteTaille RŽglage de la taille de lŽcran Taille H ResetContraste Position RŽglage de la position de lŽcran Position HRemarque Lordre des icnes peut varier en fonction du modle Bleu Niveau PrédéfRouge VertReset Moirage Augmente ou rŽduit le volume sonore Consignes de sécurité et de maintenance Usage recommandéDU Positionnement DU Moniteur Usage recommandé -suiteFixe Plug&PlayConsommation Normal ≤ 63W En veilleuse ≤ 15W Hors-tension MobileConsommation Normal ≤ 73W En veilleuse ≤ 15W Hors-tension Fiche techniques -suite AccuSyncConsommation RésolutionsFiche techniques -suite AccuSync 700M Entrée syncConsommation Normal ≤ 83W En veilleuse Fonctions Pas dimage DépannageRéférences Techform.htmÒDownloads and Drivers Ó Garantie limitée Déclaration du fabricant Série AccuSyncMC NEC NEC AccuSync Series
Top Page Image Contents