Monster Cable 300S warranty Installing the Wall Mounting Plate, Wood Stud Mounting

Installing the Wall Mounting Plate

Remove all pieces of the wall mounting system to ensure you have all the necessary parts.

Wood Stud Mounting:

1)Using an electronic stud sensor, locate a wall stud at your desired mounting location.

�����

2) ����� With the help of a friend, position the wall mounting plate on the wall stud. Using the provided level, confirm that the wall plate is plumb or vertically straight. For best results, position the level horizontally with the narrow end flush against the side of the wall plate. Hold the plate firmly in place.

3) Mark the stud center in the top and bottom mounting holes with a pencil.

4) With your electrical drill and 3/16" bit, pre-drill a 3" deep hole at each mark.

5) Attach the wall plate to the wall using the lag bolts and round washers as shown below. Tighten each bolt with your electric drill or socket wrench. Turn clockwise until secure.

DO NOT over tighten bolts. This can damage

the wall plate or the surface of your wall.

DO NOT release the wall plate until you are

absolutely sure it is secured to the wall.

8