Quick Setup Guide
Perform the following steps to quickly setup your new Hitachi Plasma Television Set.
1. ANTENNA CONNECTION
Unless your Plasma Television is connected to a cable TV system or to a centralized antenna system, a good outdoor color TV antenna is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference and multiple image ghosts, an indoor antenna may be sufficient.
a). VHF (75-Ohm) antenna/CATV (Cable TV)
When using a
To outdoor Antenna |
|
|
|
|
| To Antenna |
or |
|
|
|
|
| |
|
|
|
|
| Terminal | |
Cable TV (CATV) |
|
|
|
|
| |
System |
|
| ||||
b). VHF |
| |||||
When using a | ||||||
connect the VHF or UHF antenna leads to screws of the VHF or | ||||||
UHF adapter. Plug the adapter into the antenna terminal on the | ||||||
TV. |
|
To Antenna
Terminal
To outdoor VHF or
UHF Antenna
Air/Cable
Antenna Terminal Rear Panel Jack
c). When both VHF and UHF antennas are connected
Attach an optional antenna cable mixer to the TV antenna terminal, and connect the cables to the antenna mixer. Consult your dealer or service store for the antenna mixer.
| Air/Cable |
To UHF antenna | To outdoor antenna |
or CATV system |
Antenna Mixer
NOTE Connecting a
2. CONNECT YOUR NEW HITACHI PLASMA TV TO THE POWER SOURCE | |
a). Connect the power cord to your TV set and secure it | c). The Indicating Lamp will light Red (Standby mode) and |
with the cable tie (see page 7) . | then light blue (image displays). |
b). Connect the power cord to the AC Wall outlet .
3.POWER ON/OFF YOUR NEW HITACHI PLASMA TV.
Press the POWER button on the Remote Control or the POWER switch on the Side Control Panel for power on/off
NOTE | If the Power Switch is set to OFF, the Power Button |
| on the Remote Control will not operate. |
For
or
Indicating
Lamp
CH
CURSOR
+
VOL_
INPUT/ EXIT
MENU
/SEL ECT
POWER
4. FOLLOW THE TV SETUP WIZARD INSTRUCTIONS ON NEXT PAGE.
12