Channel Manager
Select CHANNEL MANAGER to set your Antenna options, run Auto Channel Scan, Check Signal Meter and Set Channel List.
1.Press CURSOR PAD 
, 
to highlight functions.
2.Press the SELECT button or CURSOR PAD 
to select.
|
| Video |
|
|
| Audio |
|
|
| Channel Manager | |
| + | Locks |
|
| Timers |
| |
|
| Setup |
|
|
| Move | SEL Select |
| Channel Manager |
| |
| Signal Meter |
| |
OR | Auto Channel Scan |
| |
| Channel List |
| |
| Move | SEL Select |
|
Signal Meter
Select SIGNAL METER when using an indoor or outdoor antenna. This feature will show the signal strength and peak values of the Antenna signal to help you adjust your antenna to optimize signal reception.
Channel Manager
Signal Meter
Channel
Strength 91
Peak 91
SNR 10
| Close |
Move | SEL Return |
Use the CURSOR PADS buttons 
, 
and the SELECT button to highlight and select CLOSE to exit.
NOTE | The Signal Meter will not be available (grayed out) |
| when watching analog channels. |
Auto Channel Scan
This feature will automatically store active Analog and Digital channels in Auto Channel Scan memory.
Channel Manager
Auto Channel Scan
Source |
| Air |
|
|
|
| |
|
|
| |
Auto Channel Scan | Start | Reset | |
|
|
| |
Move | SEL Return |
| |
1.Use the CURSOR buttons 
or 
to highlight AIR, CABLE (1) or CABLE(2) source.
2.Press the CURSOR buttons 
or 
to highlight the START or RESET option.
3.Press the SELECT button to select.
NOTE | If certain channels are poor or not possible in cable(1) |
| mode, set cable source to cable(2) by using the |
| CURSOR buttons or . |
Channel List
This function allows you to review which channels are labeled (ID), which have been added to CHANNEL MEMORY (SKIP), which are protected by LOCK and which are your FAVORITE (FAV)
CHANNELS.
Channel Manager
Channel List
FAV | CH# | Skip | Lock | ID | |
|
| On | Off | ||
| 4 |
| On | Off | |
| 5 |
| On | Off | |
| 6 |
| On | Off | |
| 7 |
| On | Off | |
| 8 |
| On | Off | |
| 9 |
| On | Off | |
| 10 |
| On | Off | |
No Info | AM | AM | |||
Move 
Return INFO DETAIL
1.Use the CURSOR PAD to navigate the Channel List.
2.Press the SELECT button to select ON or OFF on the SKIP and LOCK columns.
3.To select LOCK column, input the access code.(Default access code: 0000)
4.Press the FAV button to set or remove the FAVORITE settings.
5.Press the EXIT button to return to normal viewing.
NOTE | The Channel List cannot be updated by only |
| changing the cable source. Auto Channel Scan must |
| be performed for the Channel List to be updated. |
IMPORTANT NOTICE
United States federal law requires broadcasters to stop transmitting analog
After February 17, 2009, this TV’s analog tuner will continue to work with compatible cable and satellite TV systems, gaming consoles, VCRs, DVD players and other similar products.
Both before and after February 17, 2009, this TV’s digital tuner will receive available
Please review this Operating Guide for further information regarding such connections.
Hitachi supports the DTV transition and as a member of the DTV Transition Coalition urges consumers to visit these web sites for interactive guides and further detailed information:
• | www.dtvtransition.org | • | www.dtv2009.gov |
• | www.myceknowhow.com | • | www.youtube.com |
33