How to Use the Remote to Control your AV Equipment
OPERATING THE PRECODED FUNCTIONS FOR YOUR AV EQUIPMENT.
The new remote control is designed to operate different types of VCRs, cable boxes,
other audio/video equipment. You must first program the remote to match the remote system of your AV equipment (refer to pages 26~27
for a preprogrammed code number).
AV COMPONENT CONTROL SETUP PROCEDURE
111 Turn on your AV Component.
222Select the desired mode: DVD, PVR/VCR, SAT/CBL or AVR by pressing the corresponding button.
333Hold down the device button (DVD, PVR/VCR, SAT/CBL or AVR) on the remote and enter the four digit preset code that matches your device as shown on pages 26~27.
444 Release the device button.
555If done correctly, the device LED indicator will blink 3 times to confirm proper setup.
666 The remote will now control the desired device.
SETUP EXAMPLE (Hitachi Cable Box with precode 0003)
111 Turn ON your Cable box.
222Select Cable mode by using your SAT/CBL button to position the LED indicator on SAT/CBL.
333Hold down the SAT/CBL button on the remote and press the numbers 0, 0, 0 and 3.
444 Release the SAT/CBL button.
555The indicator light will flash 3 times if the code was accepted.
666Aim the remote at the cable box and press the POWER button. The remote will turn off your cable box when the correct four digit preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off, try a different four digit preset code.
777 The remote will now control your Cable box.
Repeat the same procedure for your
Power button
Numeric buttons
Device buttons
NOTES • If your AV component cannot be operated after performing the above procedures, your AV component code has not been preprogrammed into the remote.
•In the unlikely event that your AV component cannot be operated after performing the above procedures, please consult your AV component operating guide.
•The remote control will remember the codes you have programmed even after the batteries are removed from the remote control. To reset all programmed codes to factory default place remote control in TV mode, then press and hold TV mode key and enter “9”, “8”, “1” in sequence.
22