Hitachi 55HDT79 42HDX99 Remote Control for DVD Functions, Precoded DVD Buttons

Page 38

The Remote Control for DVD Functions

Operating the precoded function for your DVD

 

player.

￿

Remote Control

This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of your DVD player (refer to pages 42-43 for pre-codes).

1.Turn ON your DVD player.

2.Aim the remote control at the front of your DVD player.

3.To switch to DVD pre-coded mode, use the

SOURCE ACCESS buttons ( or ) on the remote control to position the LED light to the corresponding selection.

4.

Hold down the ENT button on the remote and enter

 

the four digit preset code that matches your DVD

 

player, as shown on pages 42-43. Release the

 

ENT button. The indicator light will flash 3 times if

 

the code was accepted.

5.

Aim the remote at the DVD player and press the

￿

+

-

￿

￿

￿

￿

The

 

POWER button. The remote will turn off your DVD

 

player when the correct four digit preset code is

 

entered. When this occurs, the remote control is

 

programmed for your DVD player. If the DVD

 

player does not turn off, try a different four digit

 

preset code.

6.

The remote will now control your DVD player.

7.

You will need to set the display type of your DVD

 

player to 16:9 widescreen.

NOTE: 1. If your DVD player cannot be operated after performing the above procedures, your DVD player code has not been precoded into the remote.

￿

/

￿

2.In the unlikely event that your DVD player cannot be operated after performing the above procedures, please consult your DVD player operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

￿PRECODED DVD Buttons

These buttons transmit the chosen precoded DVD codes.

￿EXCLUSIVE TV Buttons

These buttons are for operating the TV.

MY DVD PLAYER CODE IS:

NOTE: Refer to instruction manual of the DVD Player for operation of the buttons exclusively for the DVD Player.

38

Image 38
Contents Plasma Television Important Safety Instructions Read Before Operating EquipmentPublic viewing of copyrighted material Power sourceCovered by your Hitachi Factory Warranty Lead Notice Prevention of screen damagesFor U.S. models AccessoriesRemote Control Battery Installation Replacement Antenna How To Set Up Your New Hitachi Plasma TelevisionConnect Power Swivel Cable LocationSetting for Wall Mounting StepViewing Antenna Connections to Rear Jack PanelHook-up Cables and Connectors Quick Reference Remote Control Buttons and Functions Mode IndicatorFront/Side Panel Controls Learning AV NET sensor Power light indicatorRemote Control sensor Side Input Jacks for in PUTMonitor OUT & HI-FI Audio OUT Rear Panel ConnectionsIR Out / G-Link To Power Swivel Connector CableCARD SlotConnecting External Video Sources Left Side PanelFirst Before Operating External Video SourceOnly HDX Models Installation Recommendation Tips on Rear Panel ConnectionsConnecting a Video and Stereo Audio Source to INPUT1 INPUT5 Connecting AN S-VIDEO and Stereo Audio Source to Input 1Hdmi input Connecting External Audio/Video Devices Select Cable or AIR to return to the last channel tunedConnecting Monitor OUT Connecting a Video and Monaural AudioConnecting AN External Audio Amplifier Source to Input 1 ~ InputC B P R/C R R L C B P R/C R R L With IEEE1394 connection, video Remote Control Automatic Mode Optional modeHow to Use the Remote to Control Your TV Standard Standard ZOOM1/ZOOM2Expanded Analog Channels Digital ChannelsCursor PAD Photo InputRotate IEEE1394 only HDX Models When an IEEE1394 device is not connectedWhen an IEEE1394 device is connected Channel CH WHEEL/CHANNEL Selector buttons Volume VOL WHEEL, Mute buttonLast Channel Last CH button Dash buttonPicture-in-Picture PIP Split Mode PICTURE-IN-PICTUREPOP Mode PICTURE-IN-PICTURE PIP buttonPIP Mode PICTURE-IN-PICTURE PIPStrobe Freeze Split FreezeMain Freeze Precoded Cable BOX buttons Remote Control for Cable Box FunctionsOperating the precoded function for your cable Box Exclusive TV buttonsMY Satellite Receiver Remote Control for Set-Top-Box/Satellite Receiver FunctionsPrecoded SET-TOP-BOX/SATELLITE Receiver buttons SET-TOP-BOX Code isPrecoded DVD Buttons Remote Control for DVD FunctionsOperating the precoded function for your DVD Player MY DVD Player Code isMY VCR/PVR Code is Remote for VCR/PVR FunctionsPrecoded VCR/PVR Buttons MY Audio Component Code is Remote Control for Additional Audio EquipmentOperating the precoded function for your Audio Component How to Use the ENT Button Input AccessRemote Control Codes VCR Brand CodeSET TOP BOX Brand ..CODE Simple Remote Control On-Screen Display Vide oTV Guide On Screen Video Use the Cursor PAD White Balance Color DecodingAuto Color Black Side PanelReset Video Settings Vertical PositionAudio DRC TV Guide On Screen To Setup the TV Guide On Screen SystemSetup Procedure TV Guide On Screen TV Guide On Screen Channel Manager Signal MeterStart or Reset option Auto Channel ScanChannel List Change Access Code LocksMovie Ratings Motion Picture Ratings TableTV Ratings TV Parental Guide Ratings TableCanadian Ratings Eng Canadian Ratings English TableCanadian Ratings French Chart Alternate Ratings Example Only Alternate Ratings U.STimers Set The ClockUse the Cursor Pads to select DAY Mode on Set Sleep TimerSet Day/Night Timer Use the Cursor Pads to select DAY Mode OFFSet The Language SetupSet The Menu Options Set the Menu Background Image PowerAutomatic Power Saving Screen SaverRemote Set The InputsAuto OffAV NET Setup Wizard Example A/V Receiver Setup Press the Select button to start the Setup WizardAV NET Setup Wizard Example DVD Setup AV Net Setup Wizard Device SettingsLearning Mode Learning Mode Example A/V ReceiverSetup Use the Cursor PAD To select Other from brand name choices Learning Mode Example CUSTOM/DVD 3 Setup AV Net Setup Wizard A/V Receiver SetupDVD3 Setup Caption Display Caption ModeSet The Closed Captions Analog CaptionsVideo Out Monitor Available Monitor Out SignalsSet The Output Terminals Audio OutCableCARD Information Things to Check When UsingCableCARD / CableCARD Services Set The Quick Start Options Reset The SoftwareUpgrade NOW Insert MMC CardReset TV Settings Power SwivelSwitch ON/OFF Equipment Care and TroubleshootingTroubleshooting Do notReception Problems Troubleshooting How can I look for a specific show in the Guide? Is Help available in the Guide? If so, how do I find it?What do the frequencies for Record and Remind mean? Useful Info FCC InformationFeatures and Specifications Inch Models Plasma Television Only Weight lbs./kg 151/68.4 Set DimensionsInch Models Includes Table Top Stand Weight lbs./kg 88/39.8 Digital Media Division HitachiHome Electronics Division Canada 1-800-HITACHIEnd User License Agreement for Hitachi DTV Software END User License Agreement for Hitachi DTV SoftwareEnd User License Agreements for Operating System Software Software License InformationPreamble End User License Agreement for Operating System SoftwareGNU General Public License Version 2, June No Warranty END of Terms and Conditions GNU Lesser General Public License Version 2.1, February UXQWKDWSURJUDPXVLQJDPRGL¿HGYHUVLRQRIWKH/LEUDUySRUWLRQVRIWKH/LEUDU\ZLOOVWLOOIDOOXQGHU6HFWLRQ FDQQRWLPSRVHWKDWFKRLFH Agreements Appendixes Appendix aNo Un Selectable Index Service Information 102 103 QR66771