Hitachi 55HDT79 42HDX99 Remote Control for Additional Audio Equipment, MY Audio Component Code is

Page 40

The Remote Control for Additional Audio Equipment

Operating the precoded function for your Audio

component.

Remote Control

This remote is designed to operate different types of Audio component. You must first program the remote to match the remote system of your Audio component (refer to pages 42-43 for pre-codes).

1.Turn ON your Audio component you wish to control with the Remote.

2.Aim the remote control at the front of your Audio component.

3.To switch to Audio (AMP) component pre-coded

mode, use the SOURCE ACCESS buttons ( or ) on the remote control to position the LED light to the corresponding selection.

4. Hold down the ENT button on the remote and enter

the four digit preset code that matches your Audio

component, as shown on pages 42-43. Release

the ENT button. The indicator light will flash 3

times if the code was accepted.

+

-

The

5.	Aim the remote at the Audio component and press
	the POWER button. The remote will turn off your
	Audio component when the correct four digit
	preset code is entered. When this occurs, the
	remote control is programmed for your Audio
	component. If the Audio component does not turn
	off, try a different four digit preset code.
6.	The remote will now control your Audio
	component.
7.	Repeat steps 1 - 6 if you wish to program the
	remote to control another Audio component.

NOTE: 1. If your Audio component cannot be operated after performing the above procedures, your Audio component code has not been precoded into the remote.

2.	In the unlikely event that your Audio
	component cannot be operated after
	performing the above procedures, please
	consult your Audio component operating
	guide.
3.	The remote control will remember the

/

MY AUDIO COMPONENT CODE IS:

codes you have programmed until the

batteries are removed from the

remote control. After replacing the

batteries repeat the entire programming

procedure as stated above.

PRECODED AUDIO Buttons

These buttons transmit the chosen precoded Audio

component codes.

EXCLUSIVE TV Buttons

These buttons are for operating the TV.

NOTE: Refer to instruction manual of the VCR/PVR for operation of the buttons exclusively for the VCR/PVR.

40

Image 40

Contents Plasma Television Important Safety Instructions Read Before Operating EquipmentPower source Covered by your Hitachi Factory Warranty Lead NoticePublic viewing of copyrighted material Prevention of screen damagesRemote Control Battery Installation Replacement AccessoriesFor U.S. models How To Set Up Your New Hitachi Plasma Television Connect Power Swivel CableAntenna LocationSetting for Wall Mounting StepViewing Antenna Connections to Rear Jack PanelHook-up Cables and Connectors Quick Reference Remote Control Buttons and Functions Mode IndicatorFront/Side Panel Controls Power light indicator Remote Control sensorLearning AV NET sensor Side Input Jacks for in PUTIR Out / G-Link Rear Panel ConnectionsMonitor OUT & HI-FI Audio OUT To Power Swivel Connector CableCARD SlotConnecting External Video Sources Left Side PanelFirst Before Operating External Video SourceOnly HDX Models Installation Recommendation Tips on Rear Panel ConnectionsConnecting a Video and Stereo Audio Source to INPUT1 INPUT5 Connecting AN S-VIDEO and Stereo Audio Source to Input 1Hdmi input Connecting External Audio/Video Devices Select Cable or AIR to return to the last channel tunedConnecting a Video and Monaural Audio Connecting AN External Audio AmplifierConnecting Monitor OUT Source to Input 1 ~ InputC B P R/C R R L C B P R/C R R L With IEEE1394 connection, video Remote Control Automatic Mode Optional modeHow to Use the Remote to Control Your TV Expanded Standard ZOOM1/ZOOM2Standard Analog Channels Digital ChannelsCursor PAD Photo InputRotate When an IEEE1394 device is connected When an IEEE1394 device is not connectedIEEE1394 only HDX Models Volume VOL WHEEL, Mute button Last Channel Last CH buttonChannel CH WHEEL/CHANNEL Selector buttons Dash buttonSplit Mode PICTURE-IN-PICTURE POP Mode PICTURE-IN-PICTUREPicture-in-Picture PIP PIP buttonPIP Mode PICTURE-IN-PICTURE PIPMain Freeze Split FreezeStrobe Freeze Remote Control for Cable Box Functions Operating the precoded function for your cable BoxPrecoded Cable BOX buttons Exclusive TV buttonsRemote Control for Set-Top-Box/Satellite Receiver Functions Precoded SET-TOP-BOX/SATELLITE Receiver buttonsMY Satellite Receiver SET-TOP-BOX Code isRemote Control for DVD Functions Operating the precoded function for your DVD PlayerPrecoded DVD Buttons MY DVD Player Code isPrecoded VCR/PVR Buttons Remote for VCR/PVR FunctionsMY VCR/PVR Code is Operating the precoded function for your Audio Component Remote Control for Additional Audio EquipmentMY Audio Component Code is How to Use the ENT Button Input AccessRemote Control Codes VCR Brand CodeSET TOP BOX Brand ..CODE Simple Remote Control On-Screen Display Vide oTV Guide On Screen Video Use the Cursor PAD Color Decoding Auto ColorWhite Balance Black Side PanelReset Video Settings Vertical PositionAudio DRC Setup Procedure To Setup the TV Guide On Screen SystemTV Guide On Screen TV Guide On Screen TV Guide On Screen Signal Meter Start or Reset optionChannel Manager Auto Channel ScanChannel List Change Access Code LocksMovie Ratings Motion Picture Ratings TableTV Ratings TV Parental Guide Ratings TableCanadian Ratings Eng Canadian Ratings English TableCanadian Ratings French Chart Alternate Ratings Example Only Alternate Ratings U.STimers Set The ClockSet Sleep Timer Set Day/Night TimerUse the Cursor Pads to select DAY Mode on Use the Cursor Pads to select DAY Mode OFFSet The Menu Options SetupSet The Language Image Power Automatic Power SavingSet the Menu Background Screen SaverSet The Inputs AutoRemote OffAV NET Setup Wizard Example A/V Receiver Setup Press the Select button to start the Setup WizardAV NET Setup Wizard Example DVD Setup AV Net Setup Wizard Device SettingsSetup Learning Mode Example A/V ReceiverLearning Mode Use the Cursor PAD To select Other from brand name choices Learning Mode Example CUSTOM/DVD 3 Setup AV Net Setup Wizard A/V Receiver SetupDVD3 Setup Caption Mode Set The Closed CaptionsCaption Display Analog CaptionsMonitor Available Monitor Out Signals Set The Output TerminalsVideo Out Audio OutCableCARD / CableCARD Services Things to Check When UsingCableCARD Information Reset The Software Upgrade NOWSet The Quick Start Options Insert MMC CardReset TV Settings Power SwivelEquipment Care and Troubleshooting TroubleshootingSwitch ON/OFF Do notReception Problems Troubleshooting What do the frequencies for Record and Remind mean? Is Help available in the Guide? If so, how do I find it?How can I look for a specific show in the Guide? Useful Info FCC InformationFeatures and Specifications Inch Models Includes Table Top Stand Weight lbs./kg 88/39.8 Set DimensionsInch Models Plasma Television Only Weight lbs./kg 151/68.4 Hitachi Home Electronics DivisionDigital Media Division Canada 1-800-HITACHIEnd User License Agreement for Hitachi DTV Software END User License Agreement for Hitachi DTV SoftwareEnd User License Agreements for Operating System Software Software License InformationGNU General Public License Version 2, June End User License Agreement for Operating System SoftwarePreamble No Warranty END of Terms and Conditions GNU Lesser General Public License Version 2.1, February UXQWKDWSURJUDPXVLQJDPRGL¿HGYHUVLRQRIWKH/LEUDUySRUWLRQVRIWKH/LEUDU\ZLOOVWLOOIDOOXQGHU6HFWLRQ FDQQRWLPSRVHWKDWFKRLFH Agreements Appendixes Appendix aNo Un Selectable Index Service Information 102 103 QR66771