Hitachi 42HDT51, 55HDT51 important safety instructions CableCARD Slot, Acquiring Data Please wait

Page 13

REAR PANEL JACKS

sCableCARD Slot

This slot is for the CableCARD that will be provided by your local cable operator to gain access to chosen cable channels. The CableCARD will allow you to tune digital and high definition cable channels. Please call your local cable operator if this service is available before requesting a CableCARD (also known as Point of Deployment (POD) module).

Connect a coaxial cable to ANT A terminal of the Rear Panel Jacks.

Insert the CableCARD into the slot (Top of card should be facing up as shown).

Digital Cable

Rear Panel of AVC

END

THIS

CableCARD

T

INSER

FIRST TIME USE

If the CableCARD is properly installed or not installed, the TV will display the following respective screens.

CableCARD is installed

OR

CableCARD

is not installed

After the CableCARD is installed, wait until the second screen below appears. The third screen below will appear if a channel is not authorized for viewing. Press the EXIT button to exit the second screen.

Acquiring Data.

Please wait.

In order to start cable service for this device, please contact your cable provider

CableCARD(tm): 123-456-789-1

Host: 123-456-789-1

Data: 123-456-789-1

UnitAddress: 123-456-789-1

Press EXIT to return

Not an Authorized Channel

Please take note of all information on the screen (you will provide this information to your cable operator). Call your cable operator and give them the information from the card to start your cable service.

NOTES: 1. A digital cable subscription is required.

2.Antenna B will not be available when CableCARD is inserted.

3.Do not insert a PCMCIA card into the CableCARD slot.

4.Please see pages 63-64 and 76 for additional CableCARD information.

13

Image 13
Contents Operating Guide for 42HDT51, 55HDT51 Refer Servicing to Qualified Service Personnel Important Safety InstructionsPrevention of Screen Burn Read before operating equipmentPublic Viewing of Copyrighted Material Time USE First AccessoriesSecuring to a wall HOW to Setup Your NEW Hitachi Plasma TelevisionAntenna LocationViewing HOW to SET UP Your NEW Hitachi Plasma TelevisionHookup Cables Antenna Connections to Rear Panel Jacks When both VHF and UHF antennas are connectedVHF 75-Ohm antenna/CATV Cable TV VHF 300-Ohm antenna/UHF antennaPhoto Input Front Panel Controls4255 AVC Power button Power button Display Monitor Main Power buttonPower light indicator Remote Control sensorRear Panel Jacks Upgrade Card SUB-POWER buttonTo Power Swivel Connector RGB Analog InputAcquiring Data Please wait CableCARD SlotConnecting External Video Sources Connecting Plasma Display Monitor to AVC BOXBefore Operating External Video Source Connecting a Monaural Audio Source to INPUT1~INPUT5Connecting a Stereo VCR or Stereo Laserdisc Player Connecting S-VIDEO VCR or Laserdisc Player DVI to Hdmi Input Hdmi inputSee page 26 for tips on Rear Panel Connections Digital VCR D-VHS Connecting External Audio Amplifier Connecting External AUDIO/VIDEO DevicesConnecting AV Network Setup Procedure DVD setup example below AV Network Setup WizardAUDIO/VIDEO Codes for AV Network not for remote control Rear Panel Connections Tips on Rear Panel Connections Remote Control HOW to USE the Remote to Control Your Plasma TV Standard Aspect buttonPICTURE-IN-PICTURE button DAY/NIGHT buttonMenu button Guide buttonAV NET button RemoteAV NET Learning Wizard RemotePhoto Input Ant B Ant a Inputs buttonIeee Jump Rotate SlideshowWhen an IEEE1394 device is connected Info button When an S-VIDEOVideo Channel CH WHEEL/CHANNEL Selector buttons Volume VOL WHEEL, Mute buttonDash button Last Channel LC buttonPICTURE-IN-PICTURE PIP POP Mode PICTURE-IN-PICTUREPIP button Split Mode PICTURE-IN-PICTURE PIP Mode PICTURE-IN-PICTURESurf Mode PICTURE-IN-PICTURE NtscSplit Freeze Main FreezeStrobe Freeze Operating the precoded function for your cable box HOW to USE the Remote To Control Cable BOX FunctionsPrecoded Cable BOX buttons Exclusive TV buttonsPRE-CODED SET-TOP-BOX/SATELLITE Receiver buttons Operating the precoded function for your DVD player HOW to USE the Remote To Control DVD FunctionsPrecoded DVD Buttons Precoded VCR/PVR Buttons HOW to USE the Remote To Control VCR/PVR FunctionsOperating the precoded function for your Audio component HOW to USE the Remote To Control Additional Audio EquipmentPrecoded Audio Buttons Input Access DVD Brand Audio Brand OSD On-Screen Display Audio Channel Manager Locks Timers Setup SwivelPower Video Picture ModeON-SCREEN Display Color Management Reset Video SettingsColor Decoding Noise Reduction Auto Movie ModeAuto Color Treble Bass Balance AudioMatrix Surround Audio Source DRC Language Digital OutputAspect AspectAuto Aspect Vertical PositionSet The Antenna Channel ManagerAuto Channel Scan Channel List Signal MeterLocks Movie Ratings TV Ratings Canadian Ratings Eng Canadian Ratings English ChartCanadian Ratings Frn Set The Clock TimersSet Day/Night Timer Set Sleep TimerPlease Set Clock First Set Event TimerSet Timer Recording Menu Preference SetupMenu Background Image PowerScreen Saver Set The Inputs Video Power SaveSet Black Side Panel Video 2 Auto LinkSet Closed Caption Caption ModeChannel CableCARD Info Set Monitor OutSet AV Control Set Stand-By Mode UpgradesPower Swivel RGB on Screen Display Using the RGB InputOperation No SYNC. Signal Aspect Setup Power Swivel Move Power Swivel Unlock Brightness ContrastColor Enhancer ResetAspect Position Auto AdjustHorizontal Clock Clock PhasePower Swivel Real and Normal signals in Standard ModeInput Level Black SideDo not Care of Your Hitachi Plasma Display Your Remote ControlIgnition Noise Reception ProblemsControl Useful Info SymptomsTrademark Acknowledgment Plug and PlayAgency Regulatory Information Useful InfoOutputs InputsHome Electronics Division Dial Toll FreeDigital Media Division Hdmi IndexEND User License Agreement for Hitachi DTV Software END User License Agreement for Hitachi DTV Software Page QR60962