Hitachi 55HDT51, 42HDT51 important safety instructions Accessories, Time USE First

ACCESSORIES

Check to make sure you have the following accessories before disposing of the packing material.

REMOTE	BATTERIES	POWER CORD			MONITOR	IR MOUSE
CONTROL				CONNECTION CABLE		CABLE
TIME USE		2.		3.	4.	5.
FIRST
	TTS55 Table Top Stand		Subwoofer Cable		Cleaning Cloth	Speaker Wires
	(optional)
			6.	7.	8.	9.
	1.

CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate ventilation for the electronics or proper support for the front glass panel. This plasma television product is designed for a maximum tilting angle of 45 degrees from vertical.

2.This TTS55 stand for use only with Hitachi 55HDT51. Use with other apparatus is capable of resulting in instability causing possible injury. See important marking located on bottom of stand.

1.Remote Control Unit CLU-3841WL (P# HL02061) or CLU-3843WL (P# HL02063).

2.Two “AA” size, 1.5V batteries (P# FQ00021).

3. Power Cord:		42”	55”
	Plasma Monitor	EV01841	EV01841
	AVC	EV01841	EV01841

6.55” Table Top Stand (TTS55) (P# QJ01441K) (Optional).

7.Sub Woofer Cable (P# VZ11701).

8.Cleaning Cloth (P# MS00931).

9.Speaker wires (for monitor speakers).

4.Monitor Connection Cable (P# EW07883).

5.Two IR Mouse cables (P# EY01641).

REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT

1. Open the battery cover of the remote control by pushing the notched part of the cover with your fingers and pulling the

cover off.BOTTOM VIEW (Remote Control)

2. Insert two new “AA” size batteries for the remote control. When replacing old batteries, push them towards the springs and lift them out.

3. Match the batteries to the (+) and (-) marks in the battery compartment.

4. Replace the cover.

Press down and slide back to remove.

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalent type.

4