Hitachi 37HLX99 Remote Control for Cable Box Functions, Precoded Cable BOX buttons

The Remote Control for Cable Box Functions

Operating the precoded function for your cable box.

This remote is designed to operate different types of cable boxes. You must first program the remote to match the remote system of your cable box (refer to

pages 39-40 for pre-codes).

1.Turn ON your cable box.

2.Aim the remote control at the front of your cable box.

3.To switch to Cable (CBL) pre-coded mode, use the

SOURCE ACCESS buttons ( or ) on the remote control to position the LED light to the corresponding selection.

4.	Hold down the ENT button on the remote and enter
	the four digit preset code that matches your cable
	box as shown on pages 39-40. Release the ENT
	button. The indicator light will flash 3 times if the
	code was accepted.
5.	Aim the remote at the cable box and press the

￿

￿

+

-

￿

￿

￿

The Remote

POWER button. The remote will turn off your cable

box when the correct four digit preset code is

entered. When this occurs, the remote control is

programmed for your cable box. If the cable box

does not turn off, try a different four digit preset

code.

6. The remote will now control your Cable box.

NOTE: 1. If your cable box cannot be operated after performing the above procedures, your cable box code has not been precoded into the remote.

2.In the unlikely event that your cable box cannot be operated after performing the above procedures, please consult your cable box operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

￿PRECODED CABLE BOX buttons

These buttons transmit the chosen precoded cable codes.

￿EXCLUSIVE TV buttons

These buttons are for operating the TV.

/

￿￿

￿

MY CABLE BOX CODE IS:

NOTE: Refer to instruction manual of the Cable Box for operation of the buttons exclusively for the Cable Box.

Control

33