Hitachi 37HLX99 Remote Control for Additional Audio Equipment, MY Audio Component Code is

Page 37

The Remote Control for Additional Audio Equipment

Operating the precoded function for your Audio component.

This remote is designed to operate different types of Audio component. You must first program the remote to match the remote system of your Audio component

(refer to pages 39-40 for pre-codes).

1.Turn ON your Audio component you wish to control with the Remote.

2.Aim the remote control at the front of your Audio component.

3.To switch to Audio (AMP) component pre-coded

mode, use the SOURCE ACCESS buttons ( or ) on the remote control to position the LED light to the corresponding selection.

4. Hold down the ENT button on the remote and enter

the four digit preset code that matches your Audio

component, as shown on pages 39-40. Release

the ENT button. The indicator light will flash 3

times if the code was accepted.

￿

￿

+

-

￿

￿

￿

￿

The Remote

5.

Aim the remote at the Audio component and press

 

the POWERbutton. The remote will turn off your

 

Audio component when the correct four digit

 

preset code is entered. When this occurs, the

 

remote control is programmed for your Audio

 

component. If the Audio component does not turn

 

off, try a different four digit preset code.

6.

The remote will now control your Audio

 

component.

7.

Repeat steps 1 - 6 if you wish to program the

 

remote to control another Audio component.

NOTE: 1. If your Audio component cannot be operated after performing the above procedures, your Audio component code has not been precoded into the remote.

2.

In the unlikely event that your Audio

 

component cannot be operated after

 

performing the above procedures, please

 

consult your Audio component operating

 

guide.

3.

The remote control will remember the

/

MY AUDIO COMPONENT CODE IS:

￿

￿

Control

codes you have programmed until the

batteries are removed from the

remote control. After replacing the

batteries repeat the entire programming

procedure as stated above.

￿ PRECODED AUDIO Buttons

These buttons transmit the chosen precoded Audio

component codes.

￿ EXCLUSIVE TV Buttons

These buttons are for operating the TV.

NOTE: Refer to instruction manual of the VCR/PVR for operation of the buttons exclusively for the VCR/PVR.

37

Image 37
Contents LCD Flat Panel Television Operating Guide for 37HLX99 Read Before Operating Equipment Important Safety InstructionsPublic viewing of copyrighted material Power sourceLead/Mercury Notice For More INFORMATION, Call 1-800-HITACHIRemote Control Battery Installation Replacement AccessoriesFor U.S. models Connect Power Swivel Cable How To Set Up Your New Hitachi LCD TelevisionAntenna LocationStep Setting for Wall MountingAntenna Connections to Rear Jack Panel ViewingHook-up Cables and Connectors Mode Indicator Quick Reference Remote Control Buttons and FunctionsFront/Side Panel Controls Remote Control sensor Power light indicatorIR OUT sensor Side Input Jacks for INPUT5Monitor OUT & HI-FI Audio OUT Rear Panel ConnectionsPower Swivel Connector Upgrade CardCableCARD Slot Left Side Panel Connecting External Video SourcesFirst Digital Output Capability Tips on Rear Panel Connections Installation RecommendationConnecting AN S-VIDEO and Stereo Audio Source to Input 1 Connecting a Video and Stereo Audio Source to INPUT1 INPUT5Hdmi input Select Cable or AIR to return to the last channel tuned Connecting External Audio/Video DevicesConnecting Monitor OUT Connecting Optical OUT to AN External Audio AmplifierFollow the Setup procedure on pages Manual Mode Default mode Remote ControlHow to Use the Remote to Control Your TV Expanded Standard ZOOM1/ZOOM2Standard Digital Channels Analog ChannelsPhoto Input Cursor PADRotate Last Channel Last CH button Volume VOL WHEEL, Mute buttonChannel CH WHEEL/CHANNEL Selector buttons Dash buttonPOP Mode PICTURE-IN-PICTURE Split Mode PICTURE-IN-PICTUREPicture-in-Picture PIP PIP buttonPIP PIP Mode PICTURE-IN-PICTUREMain Freeze Split FreezeStrobe Freeze Operating the precoded function for your cable box Remote Control for Cable Box FunctionsPrecoded Cable BOX buttons Exclusive TV buttonsPrecoded SET-TOP-BOX/SATELLITE Receiver buttons Remote Control for Set-Top-Box/Satellite Receiver FunctionsMY Satellite Receiver SET-TOP-BOX Code isOperating the precoded function for your DVD player Remote Control for DVD FunctionsPrecoded DVD Buttons MY DVD Player Code isPrecoded VCR/PVR Buttons Remote for VCR/PVR FunctionsMY VCR/PVR Code is Operating the precoded function for your Audio component Remote Control for Additional Audio EquipmentMY Audio Component Code is Input Access How to Use the ENT ButtonVCR Brand Code Remote Control CodesPersonal Video Video On-Screen DisplayTV Guide On Screen Video Contrast Mode Color TemperatureAuto Movie Mode Black EnhancementAuto Color Color DecodingWhite Balance Black Side PanelVertical Position Reset Video SettingsAudio DRC Setup Procedure To Setup the TV Guide On Screen SystemTV Guide On Screen TV Guide On Screen TV Guide On Screen Start or Reset option Signal MeterChannel Manager Auto Channel ScanChannel List Locks Change Access CodeMotion Picture Ratings Table Movie RatingsTV Parental Guide Ratings Table TV RatingsCanadian Ratings English Table Canadian Ratings EngCanadian Ratings French Chart Info Alternate Ratings U.SSet The Clock TimersSet Day/Night Timer Set Sleep TimerUse the Cursor Pads to select DAY Mode on Use the Cursor Pads to select DAY Mode OFFSet The Menu Options SetupSet The Language Image Power Set The Power SavingAutomatic Power Saving Set the Menu BackgroundAuto Set The InputsRemote OffSet The Closed Caption s Caption ModeCaption Display Analog CaptionsSet The Output Terminals Monitor Available Monitor Out SignalsVideo Out Audio OutCableCARD / CableCARD Services Things to Check When UsingCableCARD Information Upgrade NOW Reset The SoftwareSet The Quick Start Options Insert MMC CardPower Swivel Reset TV SettingsTroubleshooting Equipment Care and TroubleshootingSwitch ON/OFF Do notReception Problems Troubleshooting What do the frequencies for Record and Remind mean? Is Help available in the Guide? If so, how do I find it?How can I look for a specific show in the Guide? FCC Information Useful InfoHdmi Features and SpecificationsLink Inch Models Includes Table Top Stand Weight lbs./kg 63.9/29 Set DimensionsHome Electronics Division HitachiDigital Media Division Canada 1-800-HITACHIService Information END User License Agreement for Hitachi DTV Software End User License Agreement for Hitachi DTV SoftwareSoftware License Information End User License Agreements for Operating System SoftwareGNU General Public License Version 2, June End User License Agreement for Operating System SoftwarePreamble No Warranty END of Terms and Conditions UXQWKDWSURJUDPXVLQJDPRGL¿HGYHUVLRQRIWKH/LEUDUy GNU Lesser General Public License Version 2.1, FebruaryLibrary does and what the program that uses the Library does This section is intended to make thoroughly clear what is Agreements Appendix a AppendixesSpecifications Index Page Page Page Page Page QR68671