SAFETY PRECAUTIONS
The unit emits heat when in operation. Do not place any covers or blankets on the unit, this may cause overheating. Do not block ventilation holes, or set up near radiators. Do not place in direct sunlight. When placing on a shelf leave 4 inches (10 cm) free space around the entire unit.
4 inches
4 inches
Notes when mounting the LED TV on a wall
If the unit is to be mounted on the wall, contact the retailer where you purchased the LED TV for advice, and have the equipment profes- sionally installed. Incomplete or improper installation may cause injury to you, and/or damage to the LED TV.
The screws ISO M4 thread type should be used. The insertion length must be within 12 - 16mm. If the insertion length is less than 12mm, the weight can not be maintained.
If the insertion length is more than 16mm, a space is created between the Wall Mount Bracket and the Television. (Insertion Length) = (Screw Length) - (Washers Thickness) - (Mounting Bracket Thickness)
Securing to a Wall
1.Using metallic wire fasten the set to the clamping screw on the rear of the LED TV as shown below.
2.Keep the LED TV 4 inches away from the wall except when mounted using the wall mount bracket and secure to the wall as shown below:
Wire
Screw Clamp
Wire
4 inches
Wire
NOTICE FOR TV CABINET
If the unit is to be mounted on a cabinet smaller than length of the unit, it could result in an unstable location and the unit may tumble over, making a risk of personal, possibly fatal injury. Also, this would damage the product seriously. Accordingly, Hitachi accepts no responsibility or liability for any injuries or property damage resulting from the improper installation.
YES !!NO !!
WARNING
Do not use this TV with wall mounts that allow the TV to tilt vertically. Vertical tilting wall mounts may cause structural damage to the TV. Use ONLY fixed or horizontal swiveling wall mounts with this TV.
6
3AQ0201A_eng.indd 6
5/4/10 3:27:43 PM