Hitachi UT32A302W Basic Operation Input Switching to Hdmi and RGB, Input Signal Screen Display

BASIC OPERATION (continued)

Input Switching to HDMI and RGB

By pressing the Input Select button , you can switch the input to display the image outputting from the external equipment connected to each terminal (HDMI and RGB (/Composite)).

<From Remote Control>

Press the button on the remote control.

Each time this button is pressed, the screen displays the corresponding mode in the following sequence.

HDMI RGB (/Composite)

Press the or button to directly select the input mode.

<From Control panel>

The Input modes can also be switched using the Input Select button on the control panel.

Each time this button is pressed, the screen displays the corresponding mode in the following sequence.

HDMI RGB (/Composite)

Menu button

Input Select button

RGB Input

Select button

HDMI Input

Select button

Input Select

ENGLISH

NOTE Switching between RGB and Composite Mode

When pressing button, you will see the image from either RGB or Composite mode. You can set up the mode in advance if necessary.

1.Press MENU button in RGB or Composite mode.

2.Select “Setup” menu.

3.Select “RGB input”.

Select “Composite” to display the image from a video source via the optional D-sub 15 pin - composite

cable.

Select “RGB” to display the image from PC. See 38 and 39 for details of “RGB input” menu.

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the	button on the remote control.
The display will go out in approximately 6 seconds.

HDMI mode

RGB mode

HDMI DVI 720p

RGB

H : 48.4kHz

V : 60.0 Hz

Input mode

*

Signal mode

*HDMI-DVI connection only

Input mode Input horizontal frequency Input vertical frequency

INFO button

Composite mode

Composite

24