Quick Setup Guide, Antenna Connection | Hitachi P50V702 specification

Quick Setup Guide

Perform the following steps to quickly setup your new Hitachi Plasma Television Set.

1. ANTENNA CONNECTION

Unless your Plasma Television is connected to a cable TV system or to a centralized antenna system, a good outdoor color TV antenna is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference and multiple image ghosts, an indoor antenna may be sufficient.

a). VHF (75-Ohm) antenna/CATV (Cable TV)

When using a 75-Ohm coaxial cable system, connect CATV coaxial cable to the AIR/CABLE (75-Ohm) terminal. Or if you have an antenna, connect the coaxial cable to the same AIR/CABLE terminal.

To outdoor Antenna						To Antenna
or						To Antenna
or						Terminal
Cable TV (CATV)						Terminal
System
b). VHF (300-Ohm) antenna/UHF antenna
When using a 300-Ohm twin lead from an outdoor antenna,
connect the VHF or UHF antenna leads to screws of the VHF or
UHF adapter. Plug the adapter into the antenna terminal on the
TV.

To Antenna

Terminal

To outdoor VHF or

UHF Antenna

Air/Cable

Antenna Terminal Rear Panel Jack

c). When both VHF and UHF antennas are connected

Attach an optional antenna cable mixer to the TV antenna terminal, and connect the cables to the antenna mixer. Consult your dealer or service store for the antenna mixer.

	Air/Cable
To UHF antenna	To outdoor antenna
To UHF antenna	or CATV system

Antenna Mixer

NOTE Connecting a 300-Ohm twin lead connector may cause interference. Using a 75-Ohm coaxial cable is recommended.

2. CONNECT YOUR NEW HITACHI PLASMA TV TO THE POWER SOURCE

a). Connect the power cord to your TV set and secure it	c). The Indicating Lamp will light Red (Standby mode) and
with the cable tie (see page 7) .	then light blue (image displays).

b). Connect the power cord to the AC Wall outlet .