How To Install Your New Hitachi Plasma Television
To take measures to prevent the Plasma Television from tipping over and prevent possible injury it is important to mount the unit in a stable and flat surface.
Caution when moving the main unit
As this product is heavy, whenever it is moved, at least two people are required to transport it safely. Whenever the unit is moved it should be lifted forward using the top and base on both sides of the Television for stability.
When moving the Television, lift from the corners, then support the top frame as shown below.
Location
Select an area where sunlight or bright indoor illumination will not fall directly on the picture screen. If so, drapes or screens can be used to reduce the reflection.
Also, be sure that the location selected allows a free flow of air to and from the perforated back cover of the set. In order to prevent an internal temperature increase, maintain a space of 10 cm (4 inches) from the sides/back of the Television, and 30 cm (12 inches) from the top of the television to the ceiling. To avoid cabinet warping, cabinet color changes, and increased chance of set failure, do not place the TV where temperatures can become excessively hot, for example, in direct sunlight or near a heating appliance, etc.
| 30 cm (12 inches) |
10 cm | 10 cm |
(4 inches) | (4 inches) |
Turning Angle
The maximum turning angle is 30° (left and right). Do not place any objects in the path of the television when using the power swivel feature.
(295) |
|
30° | |
| |
30° | (297) |
|
NOTES | • Do not block the ventilation holes of the Plasma |
| Television. Blocking the ventilation holes might |
| cause fire or defect. |
•In case of an abnormal symptom, unplug the AC cord and contact
•If you purchased a wall mount bracket, please ask for professional installer. Do not try to install by yourself.
•Install the unit at a proper area where it does not
expose anyone to any danger of hitting themselves (for example their hands, head or face, etc.) against the edge of the unit that could cause personal injury.
AC Cord Installation
The AC cord provided with your new Plasma Television needs to be installed correctly to avoid its disconnection when rotating the TV on its Table Top Stand.
Located on the back of the TV there are 2 plastic clamps to hold the AC cord. Please follow the instructions below.
FIRST TIME USE
Securing to a | q Pass the AC cord through Clamp #2 and then Clamp #1 and | |
1. Using 2 commercially available wood screws fasten the set |
| connect it to the TV. |
through the clamping screw holes on the rear of the Plasma | w | Close clamp #1 to fix the AC cord to the TV. |
Table Top Stand as shown below. | e | Pull on clamp #2 to tighten the AC cord to the TV. |
Securing to a Wall
1.Using metallic wire (two places) fasten the set to the clamping screw on the rear of the Plasma TV as shown below.
Wire
Wire
Screw Clamp
Wood Screws
2 places
2.Keep the Plasma television 4 inches away from the wall except when mounted using the wall mount bracket and secure to the wall as shown below:
| A | B | A | B |
|
|
| 4 in. | 12 in. |
| Wire |
| 50” |
|
|
| 10 cm. | 30 cm. | |
|
| Wire | ||
|
|
|
| |
|
|
| A: Power Swivel NOT USED | |
|
|
| B: Power Swivel USED | |
NOTE | Please adjust the wire length to avoid touching the | |||
wall when turning the TV.
How to secure Clamp #1
•To SET
Set the clamp in the direction of the arrow
Clamp #1
Clamp #2
Hook
• To UNFASTEN
Loosen the hook and pull in the direction of the arrow
7