AV Component Control Setup Procedure

How to Use the Remote to Control your AV Equipment

OPERATING THE PRECODED FUNCTIONS FOR YOUR AV EQUIPMENT.

The new remote control is designed to operate different types of VCRs, cable boxes, set-top-boxes, satellite receivers, DVD players, and

other audio/video equipment. You must first program the remote to match the remote system of your AV equipment (refer to pages 29~30

for a preprogrammed code number).

111 Turn on your AV Component.

222Select the desired mode: DVD, PVR/VCR, SAT/CBL or AVR by pressing the corresponding button.

333Hold down the device button (DVD, PVR/VCR, SAT/CBL or AVR) on the remote and enter the four digit preset code that matches your device as shown on pages 29~30.

444 Release the device button.

555If done correctly, the device LED indicator will blink 3 times to confirm proper setup.

666 The remote will now control the desired device.

SETUP EXAMPLE (Hitachi Cable Box with precode 0003)

111 Turn ON your Cable box.

222Select Cable mode by using your SAT/CBL button to position the LED indicator on SAT/CBL.

333Hold down the SAT/CBL button on the remote and press the numbers 0, 0, 0 and 3.

444 Release the SAT/CBL button.

555The indicator light will flash 3 times if the code was accepted.

666Aim the remote at the cable box and press the POWER button. The remote will turn off your cable box when the correct four digit preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off, try a different four digit preset code.

777 The remote will now control your Cable box.

Repeat the same procedure for your set-top-box or satellite receiver (select SAT/CBL), your DVD (select DVD), your VCR/

	Power	Device
	button
		buttons

Numeric buttons

Remote Control Backlight Feature

When you press any remote control button, the buttons will light up. The illumination will light a few seconds during this time. The buttons will appear to light if the room is dark.

Disabling Remote Control Backlight Feature

REMOTE CONTROL

PVR(select VCR/PVR), or your AVR (select AVR).	111	Place the RC in TV mode.
	222	Press and HOLD the TV mode key.
	333	While holding the TV mode key enter ASPECT,
		MUTE in sequence.
	444	To re-enable the backlight feature do steps 1~3
		again (these steps toggle the Backlight Feature
		ON and OFF, default is ON).

NOTES • If your AV component cannot be operated after performing the above procedures, your AV component code has not been preprogrammed into the remote.

•In the unlikely event that your AV component cannot be operated after performing the above procedures, please consult your AV component operating guide.

•The remote control will remember the codes you have programmed even after the batteries are removed from the remote control. To reset all programmed codes to factory default place remote control in TV mode, then press and hold TV mode key and enter “9”, “8”, “1” in sequence.