Side Panel Jacks & Controls
FRONT VIEW
FIRST
i
u
y
CH
t
CURSOR
+
VOL_ 
r
INPUT
/ EXIT
| e | a R/C and |
MENU |
| |
/ SELECT | w | Ambient |
| ||
| Light Sensor | |
|
|
POWER
q
o Indicating Lamp
TIME USE
POWER switch | will notify you if a software upgrade is required for your TV. |
This power switch is for the complete system. It is | In order to receive written notification, please complete and |
recommended to leave this POWER switch to ON condition | return your warranty card. |
(lights red) for |
|
MENU/SELECT button
This button allows you to enter the MENU, making it possible to set TV features to your preference without using the remote. This button also serves as the SELECT button when in MENU mode.
INPUT/EXIT button
Press this button to access the INPUT menu. This button also serves as EXIT button when in MENU mode.
VOLUME level
Press these buttons to adjust the sound level. The volume level will be displayed on the TV screen. These buttons also serve as the cursor left (
) and right (
) buttons when in MENU mode.
CHANNEL selector
Press these buttons until the desired channel appears in the top right corner of the TV screen. These buttons also serve as the cursor down (
) and up (
) buttons when in MENU mode.
INPUT-3 (SIDE) JACKS
HDMI-3
Use this side HDMI input for AV Equipment such as Set-
PHOTO INPUT/UPGRADE CARD
To view digital still pictures, insert a SD card into the card slot with pictures taken from a Digital Camera, to view them on the TV screen.
Also this card slot is for future software upgrades. Hitachi
POWER light indicator
To turn the TV ON, press the Power switch (
). A red stand- by indicator lamp located on the lower left corner of the front bezel will illuminate. The Plasma TV is now ready for remote ON/OFF operation.
Indicating | Power Status |
| Operating |
Lamp |
|
|
|
Off | OFF | When the POWER switch | |
|
| ( | ) is set to OFF. |
Lights | OFF | When the POWER switch | |
Red | ( | ) is set to ON. | |
Lights | ON | TV Power is ON; picture is | |
Blue |
|
| shown. |
Lights | OFF | TV Power is ON with no | |
Orange | (Power Saving) | signal input except antenna | |
|
| (no sync. signal) | |
Blinking | ON | When TV receives the IR | |
Blue |
| signal from the RC. | |
REMOTE CONTROL and AMBIENT LIGHT sensor
Point your remote at this area when selecting channels, adjusting volume, etc. This area also detects ambient light level for automatically brightness control of the screen.
NOTES | • Your HITACHI Plasma TV will appear to be turned |
| OFF (lights orange) if there is no video input when |
| INPUT 1, 2, 3, or HDMI 1, 2, 3 is selected. Check |
| the Power Light to make sure the TV is turned off |
| or in |
•Remote Control cannot turn ON/OFF the TV when
Power Switch is set to OFF.
•If Power Light Indicator Brightness is set to OFF, the indicating lamp will not light when the TV turns ON. Please refer to page 45.
•Please do not put anything around R/C and Ambient light sensor, as its function will be affected.
9