Hitachi CMP4221 user manual Loading Batteries, Handing the Remote Control

Remote Control

					16			POWER OFF button
POWER ON button		16
		17					16 POWER ON/OFF
	HDMI button
	RGB button	17					17	AV1 button
	AV2 button 17		17					VOLUME UP/DOWN buttons
			17					MUTE button
	AV3 button	17
				17				AV4 button
	OK button 19
				19				SELECT/OK buttons
	MENU button	19
					19			RETURN button
						18		RECALL button
	AUTO button 18
							17	SIZE button
	PIP button 25

ENGLISH

Loading Batteries

1. Open the battery cover.

Slide back and remove the battery cover in the direction of the arrow.

2.Load batteries.

Load two Size AAA batteries included observing the Polarities.

3. Close the battery cover.

Replace the battery cover in the direction of the arrow and snap it back into place.

Handing the Remote Control

Handling the Remote Control

Use the remote control within about 5m from the front of the unit’s remote-control sensor and within 30 degrees on both sides.

With in 30		With in 30
degrees		degrees
About 3m
			About 3m
	About 5m

CAUTION

zDo not use new and old batteries together. The batteries could explode or leak, resulting in fires, physical injury, or stains.

zWhen loading batteries, observe their correct polarities as marked on the product. If loaded in the wrong direction, the batteries could explode or leak, resulting in fires, physical injury, or stains.

ATTENTION

zDo not drop or impact the remote control..

zDo not splash the remote control with water or put it on a wet object.

zBefore leaving the remote control out of use for an extended period of time, remove the batteries from it.

zIf the remote control begins to lack responsiveness, replace the batteries.

zStrong light, such as direct sunlight, shining on the photoreceptor of the remote control can cause operational failure.Position this unit to avoid direct contact with such light.

11