Hitachi 28LD5000TA user manual Colour System, Video Input, AV2 1st step, AV2 2nd step

OPERATING INSTRUCTIONS (continued)

SETUP MENU

MENU P+

P-

Picture

Audio

Timer

Function

Setup

Language

Select

OK Set

	Setup						Setup
		System			System 1			Colour System
OK		Colour System				OK
		Video Input						AV1	Auto
		Audio Input						AV2	PAL
		Scart Output			Monitor			AV3	SECAM
		RGB1			DVI-STB			AV4	PAL
		RGB2			Component
					HDTV
		Select	OK	Set	Return			Select	Return		Exit
					P+
					P-
	Setup						Setup
		System			System 1			Video Input
		Colour System				OK
		Video Input						AV1	Auto
		Audio Input						AV2	Composite/Component
		Scart Output			Monitor				Auto
		RGB1			DVI-STB			AV4	S.Video
		RGB2			Component
					HDTV
		Select	OK	Set	Return			Select	Return		Exit
					P+
					P-
	Setup						Setup
		System			System 1			Audio Input
		Colour System				OK		AV1		Stereo
		Video Input						AV2		L/Mono
		Audio Input						AV3		Stereo
		Scart Output			Monitor			AV4		L/Mono
		RGB1			DVI-STB			Select	Return		Exit
		RGB2			Component
					HDTV
		Select	OK	Set	Return

ENGLISH

Selected characters		▼						▼	Setup hint
System			System1				System2		Do not change the original setting.
									(System1 : Europe/Asia, System2 : North America)
Colour System
									This should correspond to the colour system of the signal from the
									equipment that is connected to AV1 video input terminal.
		Auto			PAL			SECAM	• Normally, set this to Auto. The system of the input signal will be
AV1									automatically recognized.
		NTSC3.58					NTSC4.43		• If the input signal contains much noise or has a low level at Auto and the
									operation is found erratic, set this to match the input signal.
									• When the component signal is received, this would be not available
									(grayed out).
AV2
AV3									(Same to AV1)
AV4
Video Input
									This should correspond to the signal mode of the signal from the
									equipment that is connected to AV1 video input terminal.
AV1	Auto			HDTV				SDTV/DVD	• Normally, set this to Auto. The signal mode of the input signal will be
									automatically recognized.
									• If the input signal contains much noise or has a low level at Auto and the
									operation is found erratic, set this to match the input signal.
AV2 (1st step)	RGB			Composite/Component					This should correspond to the signal mode of the signal from the
									equipment that is connected to AV2 video input terminal.
AV2 (2nd step)	Auto			HDTV				SDTV/DVD	This step should be set only when [Composite/Component] is selected on
									the 1st step. And the procedure is same to AV1.
									• If the signal from the equipment that is connected to AV4 Scart input
AV4			S.Video			Composite			terminal is S.Video or Composite, set this to correspond to that signal.
									• If the signal is RGB, it will be automatically recognized and this setting
									will have no effect.

35