Hitachi 28LD5000TA Input Select button of the monitor or the remote control, Buttons

OPERATING INSTRUCTIONS

The functions of the buttons located on the bottom of the monitor change as shown below:

SUB-POWER button

VOLUME UP/DOWN

buttons(ADJUST buttons)

PROGRAM UP/DOWN button

(SELECT button)

INPUT SELECT button (OK button)

MENU button

POWER ON/OFF		D / N
button
		i +	I / II
INPUT SELECT
button			A / B	2-4-12
	MENU
PROGRAM UP/DOWN			P+
buttons	-		OK	+
			P-
	D V D
				FREEZE
				ZOOM
	1		2	3
	4		5	6
	7		8	9
RGB/VIDEO			0
	AV1	AV2	AV3	AV4
buttons
			RGB1	RGB2

VOLUME UP/DOWN buttons

MUTE button

ZOOM button

PROGRAM SELECT buttons

• ( ) indicates the function while the MENU is displayed on the screen.

Input Switching

•Input can be switched by pressing the AV1, AV2, AV3, AV4, RGB1 or RGB2 buttons of the remote control. And the way to return to a TV channel is as follows:

•Pressing INPUT SELECT button at RGB2 input screen.

•Pressing some PROGRAM SELECT buttons and select a TV channel.

•Pressing PROGRAM UP/DOWN buttons at the screen without OSD(On-screen display).

•Input can be switched in the sequence of TV ➔ AV1 ➔ AV2 ➔ AV3 ➔ AV4 ➔ RGB1 ➔ RGB2 by pressing the

INPUT SELECT button of the monitor or the remote control.

TV AV1 AV2 AV3

RGB2 RGB1 AV4

Size Switching

Each time the ZOOM button of the remote control is pressed, the screen display size will change in sequence and the status will be displayed at the bottom of the screen.

• During TV mode

Auto Full Zoom

14:9Zoom C14:9L

•[Auto] is the mode using WSS (Wide Screen Signals) which identify the picture format movies and programs are broadcast in. Various broadcast stations now transmit WSS. It can be detected and the monitor automatically switch to the correct format. However, some broadcasters do not transmit WSS, so this monitor will not recognize which format is being transmitted. Therefore, Default Zoom setting in the Function Menu is used to choose when a WSS has not been sent or has not been detected.

40