90CONTROLLING THE MULTIPLE PRODUCT
ENGLISH
43.Tile V Position (Command: d f) To adjust the Tile Vertical position.
*This function is available only when the Natural option of the Tile Mode is set to Off while the Tile Mode set to On.
Transmission
[d][f][ ][Set ID][ ][Data][Cr]
Data 0 to 32: 0 (Bottom) to 50 (Top)
*Bottom/Top values depend on Tile Vertical size.
**It may not be supported depending on the model.
Acknowledgement
[f][ ][Set ID][ ][OK/NG][Data][x]
44.Tile H Size (Command: d g)
To adjust the Tile Horizontal Size.
*Set Tile H Position to 0x32 before setting Tile H Size.
*This function is available only when the Natural option of the Tile Mode is set to Off while the Tile Mode set to On.
Transmission
[d][g][ ][Set ID][ ][Data][Cr] Data 00 to 32: 0 to 50
**It may not be supported depending on the model. Acknowledgement
[g][ ][Set ID][ ][OK/NG][Data][x]
46.Natural Mode (In Tile Mode) (Command : d j)
To display the image naturally, the part of the image that would normally be displayed in the gap between the monitors is omitted.
Transmission
[d][j][ ][Set ID][ ][Data][Cr] Data 00: Off
01:On
Acknowledgement
[j][ ][Set ID][ ][OK/NG][Data][x]
47.DPM Select (Command: f j)
To set the DPM (Display Power Management) function.
Transmission
[f][j][ ][Set ID][ ][Data][Cr] Data 00: Off
01:On
*Data settings may vary depending on your model as below.
Data 00: Off
01:5 sec.
02:10 sec.
03:15 sec.
04:1 min.
05:3 min.
06:5 min.
07:10 min.
Acknowledgement
[j][ ][Set ID][ ][OK/NG][Data][x]
45.Tile V Size (Command: d h) To adjust the Tile Vertical size.
*Set Tile V Position to 0x00 before setting Tile V Size.
*This function is available only when the Natural option of the Tile Mode is set to Off while the Tile Mode set to On.
Transmission
[d][h][ ][Set ID][ ][Data][Cr] Data 00 to 32: 0 to 50
**It may not be supported depending on the model. Acknowledgement
[h][ ][Set ID][ ][OK/NG][Data][x]
48.FAN Control (Command : d o) To set the Fan mode.
Transmission
[d][o][ ][Set ID][ ][Data][Cr]
Data 00: Auto
01: On
02:Manual
03:Off
**It may not be supported depending on the model.
Acknowledgement
[o][ ][Set ID][ ][OK/NG][Data][x]