CONFIGURING THE GEFENTV ETHERNET OVER COAX
Once both the sending and receiving units are linked and powered, basic
configuration can proceed. This section of the manual refers to the sending unit as the LOCAL NODE, and the receiving unit as the REMOTE NODE.
NOTE: The following steps are for manual configuration of the nodes for a basic secure network. These steps are optional, as the nodes will function with their default settings. However, for security and performance purposes, it is recommended that the following steps be performed. Automatic configuration is also possible using the Automatic Security Configuration feature on page 17 in lieu of the procedure outlined in this section.
1.Ensure that both the local and remote nodes are powered and are properly linked.
2.Confirm that the computer with the installed GefenTV Ethernet Over Coax software is connected to the local node.
3.Start the Gefen TV Config Tool from this location:
Start Menu \ All Programs \ GefenTV Ethernet Over Coax \ Gefen TV Config Tool
4.The introduction screen should appear as the image below. Click on the next button to continue.
5.The program will begin to search for all connected nodes.
12