SENDER PANEL DESCRIPTIONS
1.Standby Button
Pressing this will put the sending unit in standby mode. The unit will not transfer any information to the receiving unit in this mode. To release standby mode, simply press the button again.
2.Ethernet Input Port
Connects to the Ethernet source (i.e a router, computer, or Internet connection) via a standard network cable.
3.Security/Reset Button
Pressing this button for 2 seconds will activate the Automatic Security Configuration (please see page 17). Pressing this button for more than 10 seconds will perform a factory reset.
4.AC Power Cable Input
Input for the supplied AC power cable.
5.Coaxial Output
Coaxial output to link the sending and receiving units together. This connector will support
6.LAN LED
This LED will activate when a connection to a valid Ethernet source is established. It will blink when activity is detected to signify that data is actively being trafficked to and from the receiver.
7.Link LED
This LED will activate once a link has been established between the sending and receiving units. It will blink when activity is detected to signify that data is actively being trafficked.
8.Power LED
This LED will activate once the included power supply is properly connected.
5