Connecting the Gefentv Ethernet Over Coax

CONNECTING THE GEFENTV ETHERNET OVER COAX

1.Connect the source (i.e. computer, router, switch) to the GefenTV Ethernet Over Coax sender unit using the supplied CAT-5e cable.

2.Connect the GefenTV Ethernet Over Coax sender unit to a coaxial (RG-59 or RG-6) cable system. Please ensure that the connected coaxial cable system has an available endpoint, either directly or through a coaxial cable splitter.

3.Connect the GefenTV Ethernet Over Coax receiver unit to the coaxial cable system.

4.Connect the Ethernet devices (i.e. computer, game system, set-top box) to the GefenTV Ethernet Over Coax receiver unit. Up to four devices are supported.

5.Connect the included power cables to both the GefenTV Ethernet Over Coax sending and receiving units.

POWER LED: Once the power cable is connected, the Power LED should become active with a solid blue color.

LAN LED: When a valid Ethernet connection is detected on the sending and receiving Ethernet jacks, their corresponding LED’s will become active and should emit a solid blue color.

LINK LED: The Link LED should be ﬂashing red on initial boot up. Once a link between the sending and receiving units has been established, it will emit a solid blue color on both units.

IMPORTANT: The Link LED must be emitting a sold blue color before

conﬁguration can continue. If this LED continues to ﬂash red on both the sending and receiving units, it is possible that they are not physically connected within the current coaxial cable system. Please conﬁrm that both the sending and receiving units are attached to the same coaxial cable system.