Pioneer PDP-4270XA Preparation Basic connections, Connecting the antenna, Routing cables

05Preparation

Basic connections

Connecting the antenna

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for a coaxial cable.

3

Standard DIN45325 plug (IEC169-2)

75-ohm coaxial cable (round cable) (commercially available)

•Connect a 75-ohm coaxial cable (commercially available) to the ANT terminal.

Antenna cable (commercially available)

If your outdoor antenna uses a 75-ohm coaxial cable with a standard DIN45325 plug (IEC169-2), plug it into the antenna terminal at the rear

Routing cables

Use the speed clamps as necessary to route the connecting cables. cables. The diagrams below show the location of the holes on the rear of the plasma television.

Attaching and removing speed clamps

Insert [1] into an appropriate hole on the rear of the plasma television and snap [2] into the back of [1] to lock the clamp.

2

1

•Speed clamps are designed to be difficult to undo once in place. Please attach them carefully.

•Use pliers to twist the clamp 90º, pulling outward. The clamp may deteriorate over time and become damaged if removed.

•Be careful not to subject any connecting cables to strain.

Note

• Use the speed clamps as necessary.

Attaching the ferrite core

To help prevent noise, attach the supplied ferrite core to the connector end of the power cord as shown. Use the supplied cable tie to prevent the ferrite core from slipping on the cable.

of the plasma television.

Note

•If the antenna is not connected correctly, the quality of reception may be impaired. If images are not displaying correctly, check whether the antenna connection is correct or not.

1

23

4

Ferrite core

Cable tie

To power outlet

AC power cord

As close as possible

18

En