Pioneer PDP-4270XA Power Control, Energy Save, No Signal off, No Operation off

Setting up 08

Note

•You cannot adjust the front surround effect for listening with headphones.

•If you change the front surround effect with headphones connected, the new setting will become effective as soon as you disconnect the headphones.

• (WOW) designates a status where the FOCUS is on and TruBass + SRS has been selected for Front Surround.

• is a trademark of SRS Labs, Inc.

•WOW technology is incorporated under license from SRS Labs, Inc.

•The effect of this function differs depending on signals.

Power Control

Power Control provides convenient functions for power saving.

Energy Save

You may use one of the three Energy Save modes to save power consumption.

1Press HOME MENU.

2Select “Power Control“ (/ then ENTER).

3Select “Energy Save“ (/ then ENTER).

4Select “Save1“, “Save 2“, or “Picture Off“ (/ then ENTER).

Energy Save

Selections	Standard	Does not decrease the picture brightness.
	Save1	Slightly lowers power consumption while
		slightly suppressing the brightness drop level.
	Save2	Decreases the picture brightness and lowers
		power consumption.
	Picture Off	Deactivates the screen to save power. To
		restore the screen display, press any button
		other than i+/i– and e.
		This setting is not memorized by the system.

5 Press HOME MENU to exit the menu.

Note

•When you change the Energy Save mode, you may notice a change in the panel sound. This is normal.

No Signal off

The system will be automatically placed into the standby mode if no signal is received for 15 minutes.

1Press HOME MENU.

2Select “Power Control“ (/ then ENTER).

3Select “No Signal off“ (/ then ENTER).

4Select “Enable“ (/ then ENTER).

No Signal Off

Selections	Disable (default)	Does not place the system into the standby
		mode.
	Enable	Places the system into the standby mode if no
		signal is received for 15 minutes.

5 Press HOME MENU to exit the menu.

Note

•Five minutes before the system is placed into the standby mode, a message appears every minute.

•The system may not be placed into the standby mode when noise signals are present at the plasma television after a TV programme finishes.

No Operation off

The system will be automatically placed into the standby mode when no operation is performed for three hours.

1Press HOME MENU.

2Select “Power Control“ (/ then ENTER).

3Select “No Operation off“ (/ then ENTER).

4Select “Enable“ (/ then ENTER).

No Operation Off

Selections	Disable (default)	Does not place the system into the standby
		mode.
	Enable	Places the system into the standby mode if no
		operation is performed for three hours.

5 Press HOME MENU to exit the menu.

Note

•Five minutes before the system is placed into the standby mode, a message appears every minute.

English

33

En