Pioneer PDP-4270XA operating instructions Preparation, Reattaching the stand

Preparation 05

2Loosen and remove the two installation bolts (2) using the supplied hexagonal wrench.

English

Installation bolts (2) (M8 x 60 mm: silver)

3 Remove the plasma television from the stand.

•Make sure to keep the installation bolts (1) and (2) that have been removed as they are reused when attaching the stand to the plasma television.

Note

• Be sure to install the plasma television in a flat, stable location.

Reattaching the stand.

1Fit the stand's support columns to the bottom of the plasma television as indicated by the arrows, then slowly insert them vertically.

•Be extremely careful not to insert the support columns of the stand into any part of the plasma television other than the stand insertion slots. Doing so might damage the plasma television panel or its ports or result in warping of the stand.

Line up the column supports with the bottom of the plasma television, as indicated in the accompanying diagram.

2Attach the plasma television at the points indicated by the arrows and tighten the installation bolts (2) firmly using the supplied hexagonal wrench.

Installation bolts (2) (M8 x 60 mm: silver)

3Tighten the installation bolts (1) firmly using the supplied hexagonal wrench.

Installation bolts (1) (M8 x 30 mm: silver)

Note

•Be sure to install the plasma television in a flat, stable location.

•Insert the screws into the holes vertically and do not tighten them with more force than necessary.

17

En