Pioneer PDP-4270XA Preparing the remote control unit, Operating range of the remote control unit

Preparation 05

Note

•Disconnect the power cord from the power outlet when the plasma television is not going to be used for a long period of time.

Connecting the power cord

Rear view

Europe, except UK and

Republic of Ireland

Power cord

UK and Republic of Ireland

Preparing the remote control unit

Inserting batteries

1 Open the battery cover.

3 Close the battery cover.

Caution

Improper use of batteries can result in chemical leakage or an explosion. Be sure to follow the instructions below.

•When you replace the batteries, use manganese or alkaline ones.

•Place the batteries with their terminals corresponding to the (+) and (–) indicators.

•Do not mix batteries of different types. Different types of batteries have different characteristics.

•Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries.

•Remove batteries as soon as they have worn out. Chemicals that leak from batteries can cause a rash. If you find any chemical leakage, wipe thoroughly with a cloth.

•The batteries supplied with this product may have a shorter life expectancy due to storage conditions.

•If you will not use the remote control unit for an extended period of time, remove the batteries from it.

•WHEN DISPOSING OF USED BATTERIES, PLEASE COMPLY WITH GOVERNMENTAL REGULATIONS OR ENVIRONMENTAL PUBLIC INSTITUTION’S RULES THAT APPLY IN YOUR COUNTRY/AREA.

English

2Load the supplied two AA size batteries while inserting their respective negative polarity (–) ends first.

Operating range of the remote control unit

Operate the remote control unit while pointing it toward the remote control sensor (t) located at the bottom right of the front panel of the plasma television. The distance from the remote control sensor must be within 7 m and the angle relative to the sensor must be within 30 degrees in the right, left, upward, or downward direction.

Place batteries with their terminals corresponding to the (+) and (–) indicators in the battery compartment.

7 m

30 º

30 º

Remote control sensor

19

En