Pioneer PDP-4270XA Useful adjustment settings Chapter, Adjusting image positions

09Useful adjustment settings

Chapter 9

Useful adjustment settings

Switching the vertical drive frequency Selecting an input signal type

You can switch the vertical drive frequency for screen display between 75 Hz and 100 Hz. Choose the drive frequency that best suits the broadcast signals in your area.

1Press HOME MENU.

2Select “Option“ (/ then ENTER).

3Select “Drive Mode“ (/ then ENTER).

4Select “75 Hz“ or “100 Hz“ (/ then ENTER).

Drive Mode

75Hz

100Hz

5 Press HOME MENU to exit the menu.

Note

•This setting can be made for each input source separately.

•This setting cannot be made when 480i, 480p, 1080i@60 Hz, 720p@60 Hz, or 1080p@24 Hz signals are input.

•If you select “Auto” for “Side Mask” (see page 36), the selection for “Drive Mode” becomes ineffective.

Adjusting image positions

This setting adjusts the horizontal and vertical positions of images on the plasma television.

1Press HOME MENU.

2Select “Option“ (/ then ENTER).

3Select “Position“ (/ then ENTER).

4Select “H/V Position Adjust“ (/ then ENTER).

Position

H/V Position Adjust

Reset

5Adjust the vertical position (/) or the horizontal position (/).

6Press HOME MENU to exit the menu.

Note

•To restore the factory defaults for all items, press / to select "Reset" in step 4, and then press ENTER. A confirmation screen appears. Press / to select "Yes", and then press ENTER.

•Adjustments are stored separately according to input source.

•Depending on the displayed video, the image position may not change even after adjustment.

After connecting to the INPUT 1, INPUT 2, or INPUT 3 terminal, specify the type of video signals to be received from the connected equipment. For the type of the signals, see the operation manual that came with the connected equipment.

Before starting the menu, press INPUT 1, INPUT 2, or INPUT 3 on the remote control unit or press INPUT on the plasma television to select an input source.

1Press HOME MENU.

2Select “Option“ (/ then ENTER).

3Select “Input Select“ (/ then ENTER).

4Select a signal type (/ then ENTER).

Input Select

Video

S-Video

RGB

COMPONENT

•For INPUT 1, you can select “Video” or “RGB”.

•For INPUT 2, you can select “Video”, “S-Video” or “COMPONENT”.

•For INPUT 3, you can select “Video”, “S-Video”, or “RGB”.

5 Press HOME MENU to exit the menu.

Note

•If no image appears or images appear in inappropriate colours, specify another video signal type.

•For the signal types to be specified, check the operation manual that came with the connected equipment.

Colour system setting

If an image does not appear clearly, select another colour system (e.g., PAL, NTSC).

1Press HOME MENU.

2Select “Option“ (/ then ENTER).

3Select “Colour System“ (/ then ENTER).

4Select a video signal system (/ then ENTER).

Colour System

Auto

PAL SECAM NTSC 4.43NTSC

34

En