Epson DX-TL4E manual Connecting to the USB Port, Connecting the Power Cord

Page 20

User’s Manual

Connecting to the USB Port

Figure 14 — USB connector.

A USB port on the front panel is provided to connect external hard disk drives, CD-RW drives or flash drives for archiving video. Position the external hard disk drive close enough to the DVR so that you can make the cable connections, usually less than 6 feet. Use the USB cable provided with the hard disk drive or CD-RW to connect it to the DVR. See Chapter 4 — Operation for archiving video to an external USB-IDE hard disk drive, USB CD-RW drive or USB flash drive.

Connecting the Power Cord

Figure 15 — Power cord connector.

Connect the power cord to the DVR and then to the wall outlet.

WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING HAZARD. MAKE CERTAIN THE POWER CORD WILL NOT BE PINCHED OR ABRADED BY FURNITURE. DO NOT INSTALL POWER CORDS UNDER RUGS OR CARPET.

THE POWER CORD HAS A GROUNDING PIN. IF YOUR POWER OUTLET DOES NOT HAVE A GROUNDING PIN RECEPTACLE, DO NOT MODIFY THE PLUG.

DO NOT OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY DEVICES IN TO ONE CIRCUIT.

Your DVR is now ready to operate. Refer to Chapter 3 — Configuration and Chapter 4 — Operation.

8

Image 20

Contents Page Page Unplug the Power Cord During a Long Absence Recordable time and product warranty Disclaimer Page Table of Contents OSD On-Screen Display Setup Main Monitoring Setup Screen Clip Copy Load Default SetupLoad / Save Setup Clear All Data PTZ Mode Digital Zoom ModeList of Illustrations Alarm In Event Action Alarm Out setup screen User’s Manual Features IntroductionTechnical Overview Connecting the Video Source Package ContentsRequired Installation Tools Setting Unit for Cvbs or VGA output Connecting the Loop Through VideoConnecting Audio Connecting the Spot Monitor Connecting the Monitor Connecting Alarms Alarm Out Connecting to the Network PortAI 1 to 4 Alarm Connecting to the RS-232C Port Factory ResetConnecting to the USB Port Connecting the Power CordConfiguration Front Panel ControlsPanic Button Connecting the Infrared Remote Control Infrared Remote ControlSetup Screen Turning on the PowerInitial Unit Setup Four-Channel Digital Video Recorder Normal Setup Screen System InformationSystem Information Change screen Date/Time setup screen Holiday Setup screen User’s Manual System Check Config. screen System Check Alarm Out / Notify screen M.A.R.T. Setup screen System Log screen Configuring Input Devices Camera Setup ScreenPTZ Device list Motion Detector setup screen Text-In setup screen Text-In Generic Text setup screen Alarm Out setup screen Alarm Out Schedule screen RS232 setup screen Configuring Recording Settings Record Mode Setup ScreenTime-Lapse Record Setup screen Time-Lapse Recording Schedule screen Pre-Event Record Setup screen Event Action Setup Alarm In Event Action Record Setup ScreenAlarm In Event Action Alarm Out setup screen Motion Detector Event Action Record setup screen Motion Detector Event Action Alarm Out setup screen Text-In Event Action Record setup screen Text-In Event Action Alarm Out setup screen Video Loss Event Action Record setup screen Video Loss Event Action Alarm Out setup screen Display Setup OSD On-Screen Display SetupUser’s Manual Main Monitoring Setup screen