OPERATION
Adjusting the loud
In loud mode, use VOLUME 
/
buttons (7&8) or VOL
/
buttons(47) to switch between loud on and off. When LOUD on, "LOUD" will show on the display (4).
Directly press LOUD button (52) to reinforce the bass output. Press it again to release the function.
Adjusting the equalization
In equalization mode, use VOLUME 
/
buttons (7&8) or VOL 
/ 
buttons (47) to switch between the following mode and the corresponding information appears on the LCD (4).
FLAT
POP
JAZZ 
CLAS
Directly press EQ button (51) to turn on equalization function and to select desired audio mode as above.
Mute
Press MUTE button (3) on the front panelor MUTE button (43) on remote control to cut down sound output. Press it again to resume the previous volume mode.
Setting the clock
Press DISP button (44) to change the display into clock display. While the current time is appeared on the LCD (4), press it again to return to frequency showing.
Holding down DISP button (44) for several seconds, and the time for hours is blinking on the display (4), then press VOLUME 
/ 
buttons (7&8) or VOL
/
buttons (47) to switch between hours and minutes. Press TUNING 
/
buttons (13&14) or TUN/CH
/
buttons (46) to adjust the hours or minutes.
Note: When you first press DISP button (44), the clock will appear on the LCD, after several seconds, the clock will disappear and the LCD enter into frequency showing if you don't operate it. Then you press DISP button again, the
LCD remains the previous state and the clock will not appear. You should press DISP button once again to display the clock.
Radio operation
Switching to radio mode
Press MODE button (12) on the front panel or MODE button (42) on the remote control to select radio mode, the radio mode appears in the display together with the memory band and frequency.
Selecting the frequency band
Press BND button (11) on the front panel or BAND button (40) on remote control to select desired band. The reception band will change in the following order:
FM1 
FM2
FM3 
AM1
AM2 
Selecting station
During radio mode, press TUNING button 
(13) or TUN/CH
button on remote control to increase frequency or TUNING button 
(14) or TUN/CH 
button on remote control to decrease frequency by one step of channel spacing. Hold the button longer for fast tuning. The frequency is updated correspondingly on display.
Setting memory
Press preset memory buttons (1~6) (15)on the front panel or Radio Preset buttons(1~6) (37) on remote control to preset stations at radio mode. With this system, a total of 30 stations can be stored in the memory of six buttons. Each band stores up to six preset stations.
The stations might be FM1, FM2, FM3, AM1/MW and AM2/LW band. The operation is as below:
-Store in Memory
Press and hold desired memory location button for several seconds. The current listening station will be stored into the number button.
12