ViewSonic VS11856 user manual Remote Control direct access, Power Light, Off

Page 16

Chapter 3: Remote Control direct access

Power

Light

Power button to turn on or off the projector.

Power ON

Press

on the remote control/top panel to turn

on projector.

 

 

 

 

Press

on the remote control/top panel, it would

 

pop up a confirmation screen showing:

 

 

“Press Power Button Again to power off.”

 

Power OFF

Once this confirmation pops up, Press

on the

 

remote control/top panel again to turn the power off.

 

After lamp cooling cycle is completed, the unit will

 

enter Stand-By mode.

 

Cancel Power

Press

on the remote control to cancel the

OFF

power off process, once this confirmation pops up.

 

To illuminate remote control key pad backlight.

 

Press

on the remote control to illuminate the

Light ON, no

remote control keypad backlight. Backlight will

 

action

automatically switch off after 10 seconds, if no

 

 

other key is pressed.

Press any remote control key will illuminate the keypad backlight and calls up the function at the

Light ON, action same time.

Backlight will automatically switch off after 10 seconds, if no other key is pressed.

12

Page 15 Page 17
Image 16
Page 15 Page 17
Contents
Precision by ViewSonic Compliance Information Declaration of RoHS Compliance Copyright InformationProduct Registration For Your RecordsInstallation Remote ControlCompliance Information IntroductionPackage Contents Projector FeaturesIntroduction Projector Overview Control PanelConnection ports Remote Control PowerMenu Color TempInput Select LightLens Shift ZOOM/FOCUSInstalling the Batteries Remote Control OperationInstallation Power connectionAudio and Video Devices Connectivity Configuration HdmiInstallation Pro8100 RGB Adjusting the Projected Image Adjusting Projection Image Size Projection Screen SelectionPower Light Remote Control direct accessOFF Lens Shift Zoom and FocusAspect Ratio Picture ModesColor Temperature PCS Precision Color SystemPCS on PCS OFFBlack Level HQVHQV on HQV OFFDaylight Sensor Input SelectDirect Input Keys Remote Control direct access Main Menu Setup Menu Advanced Operation OSD MenuPicture Sub-Menu Basic Sub-MenuColor Temperature Sub-Menu Image Adjust Sub-Menu PhasePosition 71 Position 75Overscan ManualKeystone Geometry Adjust Advanced Sub-MenuAuto Auto V.KEYSTONE OFF Picture Mode LOW MID High Blacker than BlackLTI OFF CTI 3 HQVEnhancement Noise Reduction TNR MNR BAR OFFRGB Color Space Config Sub-MenuAuto Projector Settings Timeout Transparency Type Timeout 302 OSD Languages LocationTimers High AltitudeAuto Iris PCS Settings Sub-Menu Auto Iris OFF1 PCS PCS DisplayUser PCS OFF UserFlesh tone Edge Enhancement ColorGamma Correction 6 3D Color ManagementGreen Enhance Blue Cyan Magenta Yellow ColorCustom Color Memory Settings Sub-MenuLoad Custom Color Temperature Green Gain Blue Gain RED Offset Green Offset Blue OffsetSave LoadSave LoadSystem Status Screen ResetMENU/EXIT Daylight sensor status Indication if System temperature status, display if system Making Adjustments User Picture Mode Adjustments Making and Recalling the User AdjustmentsUser Color Temperature Adjustments User PCS Adjustments Recalling the User Picture Mode & Color TemperatureRecalling the User PCS Adjustments Recalling Both User Picture Mode and User PCS Custom 1Making and Recalling the User Adjustments Appendix Appendix Replacing the LampTroubleshooting List of Compatible SignalsWSXGA+ SXGA+Uxga LED Indicator Message Product SpecificationHDMI-1 RS232 command codeHDMI-2 Key-Pad & IR command Command Send String HEX Remote control code Complete IR command code tableCustomer Support Country/Region Web Site =Telephone Mail =FaxLimitation of implied warranties